Both a bicycle and a moped are very convenient vehicles. The fact is that their maintenance is not expensive. However, today many are interested in how to make a moped out of a bicycle. To do this, you need to find the right parts.
So, first you need to decide on the frame of the product. It must be strong and unbending. Therefore, it is better to give preference to the basis of a mountain bike made of aluminum. It can be folding. However, if you intend to ride over rough terrain, it is best to choose a titanium frame.
If you do not know how to make a moped out of a bicycle, do not worry,
as this procedure is not difficult. First, find the circuit by which you will install all the components on the structure. There are countless numbers on the Internet.
Now pay attention to the body kit. Best if it will be at a high level. In order for such a miracle of technology to travel, it should be equipped with an engine. Moreover, the "heart" of the design can work on gasoline or electricity. The second option is simpler and easier, since it does not require a fuel tank. However, if you do not know how to make a moped out of a bicycle that will ride on gasoline, choose an engine from garden equipment. Pay attention to the number of revolutions and weight of the device.
The engine is mounted above the front or rear wheel. Next, you need to provide a place for a gas tank or an electric battery. Naturally, it is mounted on the front of the frame. Before you make a moped from a bicycle, go through technical stores, because there you can already sell a ready-made kit for installation.
Now go to the installation of the gearbox. The easiest option is the usual not too coarse chain that connects the wheel and engine directly. You can, of course, install a variator that will not reduce engine power. As for the clutch, it is better if it is automatic centrifugal. In principle, how to make a moped out of a bicycle - of course, you only need to choose the right mechanisms. For example, when choosing a motor, pay attention not only to its power, but also to the noise level that it will emit.
The operation of such a system is quite simple: a belt or chain is attached to the sprocket, which is worn on the engine pulley. When it starts to work, the bike starts to ride. In order to start the engine, a pedal can be used.
Homemade bike mopeds can be quite convenient transportation. The fact is that they do not consume a lot of energy, are not difficult to maintain and repair, and also do not require driver rights. In addition, the cost of such a design can be quite low, which makes this technique popular.
The electric version of such a transport is more profitable, cheaper and safer. All mechanisms are mounted on special mounts that can be bolted to the frame or welded to it. That's all the features of making a homemade moped.