Almost every owner of a summer cottage is concerned about the safety of the crop, which, after harvest, is sent to the cellar. Not so long ago, it was customary to use ordinary pits for this, which were bricked. But there is a more modern solution, which is not only profitable, but also more convenient. This is a cellar-caisson, where the temperature is always maintained, which is most suitable for food and preservation. In addition, this place will not be flooded with water.
Design features and advantages of the caisson
Before you make a caisson in the garage, you need to figure out how it will look. This can be a construction in the form of a parallelepiped or circle, which has a neck and a hatch. The thickness of the ceiling and walls can be approximately 16 mm, because the surfaces must withstand the pressure of groundwater and soil.
From an excess of moisture and the formation of dampness inside the structure, you must provide for the supply and exhaust ventilation system. In order to prevent the caisson from floating under the pressure of groundwater, an anchor system should be used.
Which caisson to choose: main types, features, and functions
The pit caisson in the garage can be represented by one of several types of such cellars. Among others, a reinforced concrete structure should be highlighted. It is made of rings. Before starting installation work, a good foundation should be prepared. Once the rings are placed, a lid is mounted on top.
If the cellar is planned to be made of reinforced concrete, then waterproofing should be carried out, which should be located on the water side. Among the disadvantages of this version of the caisson, an impressive weight should be highlighted, which complicates the installation and conduct of waterproofing.
Reinforced concrete caisson is quite expensive. If you are limited in money, then it is better to choose another variety. Owners who already have reinforced concrete caissons quite often recommend choosing plastic or metal structures.
How to make?
If you have a question about how to make a caisson in the garage with your own hands, then you can consider the metal structure. Such a cellar is one of the most popular. It is made of steel 20 mm sheets. The material is welded into an airtight cube, a ladder is installed inside; the design is complemented by a hatch that is treated with an anti-corrosion coating. Such a system helps maintain the optimal temperature inside, which is suitable for storing preserves and vegetables.
Sometimes groundwater enters such a pit, so a bypass valve should be made. The caisson in the garage can also be made of plastic. It does not need anti-corrosion treatment and has low weight. When installing such a design, there is no need to use additional equipment. The plastic model has a high tightness, therefore, waterproofing protection is not necessary. The plastic caisson has been working smoothly for several decades.
Self-made metal caisson
When choosing a place for a caisson, you should remember that the cellar should be located in the center of the underground space so that the walls are blown with fresh air. You must provide an entrance with steps. The hatch should be well closed with a lid that fits flush with the floor. The cover is usually made of the same boards as the floor.
A caisson is installed before the construction of the main building. The surface where you plan to install it should be carefully inspected. If the site is located in a high, dry place, then there should be no problems. But when the soil is swampy, you have to work hard. It is important to choose the right welded metal box, which has high reliability.
The seams of the caisson in the garage should be well boiled inside and out so that water does not penetrate there. If you do not pay due attention to this issue, then the corrosion damage will come quite quickly, and you will have to carry out repairs. The walls and floor of the caisson are made of metal, while the upper part can be made of concrete or wood.
Work on a pit and a catchment basin
Before installing the caisson in the garage, you must determine the size of the pit and mark the area. To equip the metal cellar, it is necessary to prepare a pit, deepening by 2.5 m. The marking should be done so that between the walls of the caisson and the walls of the pit there is a distance of 0.5 m. This gap should be around the entire perimeter.
It is important to keep the turf so that the walls do not crumble. During digging, there may be problems with water that accumulates in the top layer of peat. The latter is supported by clay, there may be water. In order to solve the problem, a pit is dug in the center of the pit, and it is necessary to go deep into the bayonet of a shovel. This will allow you to get something like a catchment. As soon as the pit is dug up, the bottom is covered with sand to form a pillow. Its thickness should be 10 cm. For reliability, the walls and bottom of the caisson are treated with tar.
The caisson in the garage should be as tight as possible. Before proceeding with the installation of a metal cellar, the walls are treated with an anti-corrosion coating. You can make bituminous mastic yourself using a boiler. Bitumen is loaded into the tank on a third of the volume and put on fire. You must wait until all the moisture has disappeared. This will happen when the mass ceases to foam.
The molten bitumen is poured into an open dish with gasoline in a thin stream, the resulting composition mixes well. To primer the outer walls of the cellar, it is necessary to take bitumen and gasoline in a ratio of 1 to 3. The mixture for the first layer is prepared in a ratio of 1 to 1. This composition should be applied in a continuous layer, special attention should be paid to sharp corners.
When installing the caisson in the garage with your own hands, you must insulate it. Particular attention should be paid to the bottom and walls. The caisson is installed on a clay insulating solution, the thickness of the layer should be 200 mm. The outer sides are insulated with thick thick clay, the layer should have the same thickness.
In order to achieve greater reliability, it is necessary to plaster the internal walls and floor with cement mortar. It is laid in a layer of 20 mm. In order to avoid difficulties, it is necessary to pull a metal frame made of wire, the thickness of which is 6 mm. The mesh size should be 30 x 30 mm, but no more. The wire is tied to the frame, only after you can proceed to plastering the walls.
Next, prepare a concrete composition that is laid on the floor with a layer of 35 mm. Once the layer is evened, it is left to dry. The inner walls of the steel caisson are insulated with glass cloth or blankets. Glass wool is laid between the fabric webs.
Installation of the structure in the pit
At the next stage, you can lower the caisson into the pit. From two sides, logs are lowered, which will act as guides and limiters. This will allow the installation to be exactly centered. You can install the structure inside with the help of a winch, which is fixed by a set stump. One person should loosen the cable, while his assistants will guide the frame, excluding the swing.
At this stage, you may encounter certain difficulties when the caisson will play the role of a floating ship. If water constantly enters the pit, the caisson will float. In order to exclude this, you should start installing a water seal. To do this, the distance between the walls of the cellar and the pit is filled with clay. Each layer is well compacted. A water trap is located below the freezing line, at a depth of 1.5 m.
When installing a caisson in the garage, when a water lock is performed, you will not be able to get a full guarantee that no water will flow under the cellar bottom. The danger of surfacing still remains. In order to avoid problems, when installing a caisson, it is necessary to use the principle of a submarine. Water is drawn into the ballast tanks, and the air is forced out, then the boat gets negative buoyancy.
At the bottom of the caisson, you need to make a hole with a separate pipe. At first they do not drown it, but leave it open. After the first rainfall, about half a meter of water will be drawn into the cellar, which you will have to draw. After repeated rain, there will be little liquid, so soon the cellar will not absorb it. The vovkhodka will fill the cracks with watery clay, which will contribute to the reliable installation of the cellar and isolation. After this, the pipe is muffled, but in the first year of using the cellar, you can not do this.
What is a caisson in a garage? The photos presented in this material demonstrate the answer to this question. In addition, information about the purpose of the cellar was presented above. From it you were able to find out that ventilation in the pit for storing vegetables and pickles is mandatory. To do this, take two pipes of any material. Supply and exhaust pipes are installed in different angles so that the first is lowered low to the floor. The step between the end of the pipe and the base of the floor should be 20 cm.
The hole is closed with a grate so that debris and small rodents do not get inside. Ventilation in the caisson of the garage involves making a hatch in each of the pipes so that you can clean in the event of a blockage. The exhaust pipe must be raised under the ceiling so that it draws out the accumulated warm air.
Any cellar can become a real helper in the household. But this is true only if it is properly equipped. The basis can be metal or plastic.