Wire connection

With any wiring device, reliable wire connection is required. In the middle of the last century, when housing was massively built, wiring was carried out by aluminum wire. This was done for economic reasons. The connection of wires in such wiring was carried out by the method of twisting. If the twisting was performed correctly, then such a connection without preventive maintenance served for quite a long time.

Wire connection

In those days, it was the most reliable connection, and there simply were no other ways. There were no particular problems, since there were few household appliances in the apartments of ordinary citizens, and the power consumption remained small. Therefore, wiring from an aluminum wire and connecting the wires with twisted wires satisfied everyone.

Today, literally every apartment is crammed with household appliances and appliances. The power has increased, therefore, special requirements are imposed on the wiring, which are stipulated in the Rules for the installation of electrical installations. According to this document, the connection of wires can be made only in three ways: by welding, soldering or using clamps.

There is no twist in this list. Twisting is permitted by current rules, but this connection must be temporary before welding or soldering.

Junction box wires

Welding is the connection of wires by contact heating of their ends with a carbon electrode to form a contact point. This method is very reliable and high quality.

Before welding the wires, insulation is removed from their ends and twisted. A flux is poured onto a flat electrode, where we subsequently lower our twist. We press it to the electrode and start the welding transformer.

The ends of the twist fuse. The result is a contact point. Further, the compound is coated with a special varnish and insulated. This is how the wires are welded.

Wire welding

You can connect the wires with molten solder. This method is called soldering. To solder the wires, remove the insulation from their ends and connect them. You can twist. The solder warms up the solder and is transferred to twisting. After hardening, the solder is washed with alcohol and isolated

Crimping. For this type of compression connection, you need a hand press. The connected wires are twisted. The twist is placed inside the copper tube and pressed.

And finally, a screw connection. This connection is made using the terminal block. The twist is inserted into the terminal strip and clamped with screws, and then simply insulated.

And where can I apply the wire connections described above? Usually they are made in distribution boxes. The connection of wires in the junction box can be performed by different methods. Each electrician has his own technique, but most often an insulating clamp connection is used. It is very reliable. And the main thing is that it is a detachable type of connection. If something the electrician did not like or something was done wrong during the installation process, then such a connection can be quickly disassembled to correct an error or inaccuracy and just as quickly make the correct installation.

Source: https://habr.com/ru/post/A12740/

All Articles