Installation of the installation of the toilet involves mounting it with a supporting metal structure made in the form of a frame. The installation of this plumbing equipment can be carried out both in private houses and in apartments, cottages, dachas and even baths. And despite the fact that the design of this device is very complicated, there are practically no problems with its installation. Moreover, the installation of this equipment can be done without the help of specialists and the use of special tools. Further in our article on how to install a toilet installation with your own hands.
What is the essence of the work?
How is it that the design of the hanging toilet is complicated, and the installation can be done by limiting itself to a minimum set of wrenches and a drill? The fact is that the manufacturer took care of this stage in advance and provided for all possible difficulties. In fact, the installation of the toilet installation is reduced to connecting the device to the water supply, sewage and fastening the bearing beam.
Getting to work
It is also worth noting that despite the varieties of this equipment, the principle of their installation remains the same, therefore, this instruction below can be applied to absolutely any wall-hung toilet.
At the first stage, it is necessary to install the frame in a niche. If the latter is not, then the structure is mounted to the wall: all calculations are adjusted in height so that the distance from the toilet to the floor is no more than 40 centimeters. This value corresponds to the normative size of an adult.
After that, in the wall or on the floor, the center of the fixing holes in the brackets is marked. According to the scheme, the work is performed as follows: dowels or anchor screws are driven on a concrete or brick floor, and self-tapping screws on a wood floor.
Further, the installation of the toilet installation is accompanied by the installation of the module (it is important to avoid gaps) and connecting the device to water supply and sewage systems. After that, under the threaded rods and the push-button drain module, the mounting casing is attached and the wall is sheathed together with the module itself. However, at this stage, the installation of the toilet installation has not yet been completed. After mounting the casing, it is necessary to put on the threaded rods a special sealing gasket and tighten all the nuts of the device.
In this case, the toilet should be in close contact with the surface of the wall and floor. The drain mechanism is connected to the tank through a small plastic tube and inserted into a rectangular hole, which should form when the drainage cover is trimmed. Everything, at this stage, the installation of the
hanging toilet with installation has been successfully completed.
Tip
Finally, we note that for further adjustment of the water supply and the drain rate, you must first pull out the button module, after which all hidden mechanisms will be available to you, including the place of water supply and the float system.