If you still do not know how to cover the roof with your own metal tile , the presented material will be very useful for you. First of all, it is worth mentioning the benefits of this finish. So, the metal tile is a strong, lightweight, durable and resistant to negative influences material. In addition, it is sold in any store and has a low cost.
Now we turn to the question of how to cover the roof with a metal tile with your own hands. First of all, you need to assemble the right tool: drill, hammer, hacksaw, metal scissors, grinder. As for the metal tile itself, it can be of different colors, and also have a flat or corrugated surface. To calculate the required amount of material, you need to correctly measure the total area of the roof slopes and divide it by the size of one full sheet. The roof should be bought with a margin. It will be nailed to the crate with the help of galvanized nails.
If you know how to cover the roof with your own metal tile, you should not forget about the main requirement for using the presented material: the roof slope must have a minimum angle of inclination of 14 degrees. Now you can start preparing the base foundation, that is, the crates. It must be done from flat wooden boards 3 cm thick. Naturally, all wood elements of the lathing and the rafter system must be treated with an antiseptic. Further waterproofing is laid on the surface.
If you have already read how to cover the roof with your own metal tile, do not forget to decide which side you will start laying. Naturally, the first row of sheets is stacked from the bottom of the ramp. At the same time, it should be mounted so that the edge of the metal tile extends beyond the edge of the crate by 3-4 cm. Do not fasten the first sheet immediately tightly. You will do this after putting a few more elements. They need to be laid with an overlap, the size of which is 10 cm. The metal tiles are screwed with roofing screws, on which there must be a special sealant that prevents surface damage.
In principle, we already know how to properly cover a roof with a metal tile. The whole procedure does not take much time. Work should be carried out in the warm season and in dry weather. Etc
and need sheets of material can be cut using a grinder. The only restriction that does not allow the use of such a roofing is the complexity of the roof. In addition, the order of fastening of the sheets may vary depending on the shape of the rafter structure. For example, if the roof is hipped, then the fastening of the metal tile starts from the highest point. In this case, the material should be fastened to the ridge as firmly as possible.
During operation, move around the roof carefully and carefully so as not to fall and not damage the sheets. Doing it yourself with a metal tile is relatively easy if you stick to the technology. That's all the features of the process. Good luck