Every motorist is faced with a situation when it is necessary to replace tires. And often the procedure takes place in specialized workshops. But there are situations when there is no way to contact the service. Then the motorist performs installation and disassembly. For such cases, a homemade tire changer is needed . Do it yourself with your own hands will not be difficult. Before you begin, you should consider how to do this.
What is the unit for?
Do-it- yourself homemade tire changer (photo below) may be required in a variety of cases. When the tire has expired, it should be removed. This procedure is not as easy to perform as it might seem at first glance.
Some drivers use special mount kits for these purposes. However, such a tool may not always help to dismount a disk. Especially often, this situation occurs after prolonged use of the tire. Mounts are soured, covered with a layer of dirt. In this case, you may not be able to manually spin up the disk.
It is for such cases that a homemade tire changer is used . Do it yourself with your own hands to create such a design. This is an effective device that will help greatly facilitate the process of dismantling and installing a new tire.
Design Efficiency
A do-it-yourself homemade tire changer, the drawings of which are not very complex, can become a truly effective tool. To ensure high speed installation of a new tire, you will need to consider the main elements of this design.
The machine consists of a frame, a pipe for the handle and a vertical riser. All elements are made of metal. Two pipes are used as a frame. They should be located in parallel. This is necessary to give the structure on which the load will act, strength. A steel corner will help connect them.
A vertical riser is mounted to the frame. With its help, the lever is fastened, the platform for installing the wheel disc. Instead, you can weld a flange.
The pipe for the handle acts as a lever. This will allow you to simply dismantle the tire. All of these items must be durable.
Build Features
There are a number of expert recommendations on how to make a homemade tire changer with your own hands. The distance between the pipes should be 700 mm. Using a corner, they are connected together to give the structure the necessary rigidity.
If desired, the design can be equipped with additional legs for adjustment. Next, you need to use welding to connect the pipe and the crossbar. Before this, a flange must be welded at a height of 50 cm.
A steel plate will serve as a fastener. It is mounted on a vertical pipe. The plate is needed for mounting the lever. He, in turn, will dismantle the tire. This structural element consists of a shoulder, which is attached to a horizontal stand, and a foot. With its help, the master will be able to transfer the necessary physical effort to the bus.
Advice
A do-it-yourself home-made tire changer will help to separate the tire from the disk. After this, the worn product must be completely removed. It is recommended to use the mount. The handle should be welded to it first.
The disk must be mounted on the flange. It is fixed with a clamp. With the thin end of the mount, you need to bring the edge of the tire beyond the outer rim of the disk, then turn it over. This will allow complete dismantling of the tire.
You should perform this procedure quite carefully. Do not damage the edge of the disc. Otherwise, subsequent installation will be quite problematic. The mounting must be lubricated with oil. This will prevent tire rubber from tearing. A new tire is mounted using a soap solution. They lubricate the inner surface. This will make it easy to install a new product in its intended place.
Having considered the features of creating a do-it-yourself tire changer with your own hands, it will not be difficult to perform such a job. It will be possible to disassemble the design of the car wheel even if the elements of the system are very acidic. This is a convenient tool that will be used by the vehicle owner more than once during the tire change process.