Melt water at home, can be used for cosmetic purposes, it is rubbed by the elbows and heels, after several such procedures roughened

Very important, in our life, is the question: "How do we replenish the water balance of our body" - well, the answer is obvious. Of course, with water!

Only water - water is different, it has long been known to everyone that water carries not only life-giving moisture for all living things, but also some information. Water from different sources has a different formula, this is understandable, somewhere the soil contains more than some minerals, somewhere else, it would only be nice if the question is precisely in minerals and trace elements. But, in fact, everything is more serious, the water of our time is overflowing, at best, with heavy metals, and what brings the worst case, itโ€™s better not to even think. It happens that you watch a program about which country's reservoirs were checked for compliance with the norms and standards adopted regarding the composition of drinking water, you give yourself the vow to drink water, only purchased water.

And this, even, could be a good alternative, but it doesnโ€™t check for this conformity, not only ordinary drinking water sold as artesian or mineral water, but also water sold as water for babies. Mom gives a bottle of baby water, one and a half or two times more money, not suspecting that this water carries no less danger to her child.

What then to do? What filters to use? What is the way out?

At the expense of filters, I can answer what is among them, really worthy specimens, but not about our money. But I see one way out - melt water, at home. Melt water at home, this is the cheapest, unless of course you buy, especially for this a new refrigerator, and the most effective method of purifying water from unnecessary impurities and negative information.

Much earlier, our great-grandfathers knew, without unnecessary troubles, what it means to prepare melt water at home, for this, all that was needed was to collect snow into a bucket and wait until it melts. Now this method can be compared to suicide. Melt water at home, this century, is produced using a slightly more sophisticated technology.

So, to make melt water at home, it would turn out to be of excellent quality, choose a container that should be enameled or stainless steel (enameled, itโ€™s still better), it often applies to glass, plastic and aluminum containers, then you should not use it at all, so how these materials have insufficient thermal conductivity.

Before preparing melt water at home, tap water will need to be brought to a temperature of 95 degrees, when the water is almost boiling. Turn off the water and place in another vessel with cold water, of course, the vessel should be larger to accelerate the cooling of water. It is better if the water is changed several times so that the water in the second vessel is not hot.

A vessel with cooled water is placed in a freezer, in other words, in a freezer. Water should be in the freezer until half of the tank turns into ice. We take out the water from the freezer and drain the unfrozen water, since this is the content of all harmful impurities. The icy half of the vessel should be thawed and boldly used for teas, soups, washing and rubbing.

If the preparation of melt water at home was delayed so that it was not possible to ensure that the water did not freeze completely, it would be freed from heavy metals and other dirt, you could put an ice block under the stream of hot water, but you need to do it this way, so that a stream of water falls into the middle of the block. It is in the middle that there will be unsuitable water for consumption.

Melt water at home, can be used for cosmetic purposes, it is rubbed by the elbows and heels, after several such procedures, the roughened areas become surprisingly soft. The same applies to facial skin, if you wipe your face with melt water, it will soon begin to delight you with a noticeable rejuvenation.

Source: https://habr.com/ru/post/A903/


All Articles