Today, the plastics industry is developing rapidly, its use in engineering is especially popular. When buying a brand new motorcycle or scooter, you are happy looking at its smooth shiny surface. But, unfortunately, there are cases when the plastic surface breaks down, deteriorates under the influence of any external influences or wears out over time.
Plastic repair of your favorite motorcycle can be done in a car service, or you can save money by making everything yourself in your garage. Before proceeding with the repair, it is necessary to determine the brand of plastic material from which the damaged part is made. To do this, look at the back of the product, there is a signature “ABS” or “PP”. If, for a number of reasons, the recording is missing, this place has been erased or damaged, the brand can be identified by its smell during combustion. It is not necessary to set fire to the entire part, it will be enough to have a small corner in an inconspicuous place. The ABS brand has a sharp, sweetish smell, and the PP brand has a
wax candle aroma
. Having determined, you can begin the process of correction.
The choice of the type of repair
Plastic repair can be done in several ways, which depend on the material and the nature of the damage to the part. With surface scratches that violate only the paintwork, the correction is reduced to restoring the original appearance. The deepest scratches before painting should be puttied with special mixtures. If the damage has reached the formation of cracks, the defect is glued, welded or repaired by heating.
The latter method is used to eliminate dents on a thermoplastic. Using a temperature of about 200 degrees, gradually warming the plastic surface, it is necessary to restore its original shape by mechanical action. Bonding is the process of forming a joint due to the adhesion of the soldered part to the adhesive composition. Bonding plastic is popular in the repair of thermoset plastics. The use of modern adhesive compositions, which are high molecular weight compounds, makes it possible to repair both thermoplastics and thermosets, which, after hardening, turn into
polymer material. Plastic repair of a scooter or motorcycle is most often performed by the welding method, since it is the most durable and preferred for parts made of thermoplastics. The welding process itself is a fusion of fragments.
DIY plastic repair by welding with your own hands
Having determined the brand of material and the method of repair, you should prepare the plastic part, thoroughly washing and cleaning it from pollution. The corners of the edges to be welded must be cut from the inside and outside so that triangular gaps are formed for laying the molten plastic. From pre-prepared additional plastic, cut rectangular pieces equal in size to the width of the gaps. To melt the spiral, heat the wire, while you need to be extremely careful so as not to boil the plastic through, but also to make enough adhesion joints. Brewing should start from the dead end of the fault, first from the inside, and then from the outside. After hardening, process the seams with a fine sandpaper to a smooth surface. This will complete the plastic repair.