Sliding gates have a console system. In this design, movement is carried out along two roller bearings, which are installed on one side of the passage.
Such gates can be used on any territory of our country, since snow deposits do not affect their work. The canvas along the leading edge is located on the trap when they are in the open state. Thus, the roller bearings are unloaded, and therefore their working life will be preserved for a long time.
Cantilever sliding gates have a design that consists of rails, a set of roller bearings and traps, as well as a profile pipe. The production of sliding gates is based on the use of high-quality components manufactured in our country. Depending on the dimensions, it is necessary to use very strong roller bearings and rails that can withstand heavy loads. The size of the gate can be up to 7 meters wide. For individual orders, they can be made with a width of up to 12 meters. Height can reach 3 meters. The design is always treated with soil and painted in any color.
Gates are also made with integrated automation, it all depends on the wishes of the customer.
Automatic
entry gates require additional preparation of their canvas. For this, a metal gear rack must be installed along the entire length of the rail to ensure the operation of the electric drive. In sliding versions,
a control unit with radios is used. Such gates are often installed in private homes.
The powerful drive has a built-in unit to allow flexible variation in the composition of the system. The set of automatic gates should include remote controls, photocells, gear racks, warning lights, selectors, antennas and more.
When sliding gates are manufactured, their cost will depend on self-supporting rails and roller bearings. When making cheap copies, they usually try to save. Therefore, they begin to use products of unknown manufacturers of low-quality metal or replace them with home-made analogues.
The design of sliding gates allows you to open them manually or using an automatic drive. When a sliding gate is installed, it is made so that the components do not touch the ground. The upper part is fixed using the side rollers. With their help, you can limit the amplitude of swinging of the gate. The production of sliding gates has strictly limited standards that help all elements to be in the right position while maintaining balance.
Sliding gates can have four types:
1. An open profile with a beam located below.
2. With the upper beam.
3. With a closed profile with a lower beam.
4. Telescopic gates.
All these types have their own fields of application and operational features.
When choosing such products, you need to consider where the gates will be installed. It is better to entrust the production of sliding gates and their installation to professionals so as not to worry about their smooth operation.