Windows 7 update error (code 80073712) - a failure is quite common. It belongs to the category when impatient users, when installing standard update packages, usually in the amount of 73 pieces, immediately after installing the system itself and connecting to the Internet, so as not to wait or waste time, just turn off the computers or force the system to reboot .
Windows 7 Update Center Error 80073712: What is this Failure?
The failure itself only indicates that during the download process the components of CBS (component model) were damaged. It turns out that updates are not installed from the official Microsoft website, even if manual search is enabled.
Moreover! When you try to activate or disable system components, the list does not display anything at all. Thus, as Microsoft Support says, the problem is the corruption of the Update Center manifest. The manifesto is precisely the declared support of the system components, for which the installation of updates is provided initially and fundamentally.
Causes of the error
Let us leave aside error code 80073712 of the “Update Center” of Windows 7, and talk about what could cause this behavior of the system. The most important reason has already been said. However, not only it can cause the appearance of such a failure.
Often, although indirectly, a Windows 7 update error (80073712) can be associated, for example, with a banal power outage during the installation of packages. In addition, the “Update Center” itself may not always be the primary source. Some system-forming files may be corrupted.
Windows 7, update error 80073712: hotfix
Now - directly about the correction. In the most general case, the update error 80073712 for Windows 7 can be fixed by using the launch of the command console either on a working system or when booting from the installation disk or recovery flash drive.
In the first case, the console must be run as administrator. In the second role it does not play. After entering, you need to register two lines, as shown in the image below.
It is also necessary to use pressing the enter key after each command. The lead time can be very long, but what to do - will have to be patient.
On the other hand, the update error 80073712 for Windows 7 can be fixed by using the scan and restore system files command. For this, the same console is used, but with the sfc / scannow line specified.
Finally, you can go to the system folder, find the SoftwareDistribution directory there, rename it or delete it completely, reboot, and then enable manual update checking.
As the last resort, many users and specialists in their field are advised to re-install the latest service pack. You can download it without any problems from the official resource of the developer corporation. But using unverified repacks downloaded from dubious sites is not recommended at all. As a result, you can get a simply inoperable system that will not respond to user actions (although before that it behaved more or less decently, despite some obvious problems with installing updates).
Total
As a result - checking system files or restoring performance using DISM commands, reinstalling the service pack (if you do not want to reinstall the entire system), as well as deleting the above system folder.
If all else fails, try using the DLL Suite utility. Perhaps what was missing was damaged or undergone a critical change. Needless to say, do not forget that some viruses can also actively affect system updates. Therefore, in some cases it can be useful to start a virus scanner initially, and only then use all other methods that have been proposed above. It is better not to touch the installed programs, but to use portable utilities, and even better, boot from a Rescue Disk disk or flash drive, and then perform an in-depth analysis using the hard drive, logical partitions, boot area, RAM and virtual memory. Viruses, even those sitting very deep in the system, are removed with such tools in one hundred percent of cases.