A hair clipper is now considered a very popular and, most importantly, economical purchase. The advantages are immediately apparent: you do not need to cut time to visit the hairdresser, to sit in line, as you can cut your hair at home at any time convenient for you. Of course, these are undoubted advantages. But besides this, you also need to know how to use the machine to create a beautiful male haircut.
Haircut: a description of the process
First you need to comb, so that the hair lies in its natural direction and order. A man needs to start a haircut from the forehead, and if he has long hair, then they must be combed forward. Then raise them with a comb and install the machine in the place where they begin to grow, that is, at the roots.
If you want to make short men's haircuts for a typewriter, then you don’t need to wet your head before the start of the process. Using the largest nozzle, cut the hair in the crown of the head, and then gradually drive the machine toward the temples. Note that you must enter the tool against hair growth, and not vice versa.
When performing men's haircuts, you can make many movements, pressing the nozzle to the surface of the head, but in no case do not change the angle and distance between the machine and the head. The more often you comb your hair and walk through it with a machine, the better the haircut will be, as well as the final result.
A haircut under the machine is always performed so that the comb rests in the left hand. This will allow you to thoroughly comb your hair and simply press it to the palm of your hand, slightly holding it with your fingers.
Men's haircut under the machine is performed in stripes, first in the middle of the head, and then on the side, and so on to the ear (according to the same pattern, to the second ear). Replacing the nozzle with a smaller one (2 times less), go to the back of the head. You need to start the movement from below, then rise higher. Moreover, on the back of the head you need to press the machine to the head, and rising to the crown of the head, it needs to be slightly lifted. This will make it possible to even the difference between the length of the hair and make the transition smoother. Using the same nozzle, you need to cut the whiskey, moving in the direction from the bottom up.
Above the auricle, hair grows in opposite directions - towards the temple and neck, therefore, cutting under the machine in this area is performed with a change in the direction of movement of the instrument, but only against hair growth. It is recommended to bend the
left ear slightly with the
left hand, and the right one with the little finger of the right hand so as not to injure the skin.
The haircut under the machine ends with removing the nozzle from the blades. For a better result behind the temples and on the neck you need to make a border without it: the blades will not leave any gun on the neck and cut off the hair completely.
At the very end of the work, check the length of the hair over the entire surface of the head with a comb. If there are irregularities and inaccuracies, you can fix them with thinning scissors.
For the long service of your machine you need to take care of it. After each haircut, you need to brush it well, removing all hair from the surface of the knives. And, of course, do not forget the basic rules for using the tool.