Intex air mattresses quickly entered our daily lives. They are very convenient: they can be used both at home, when guests suddenly arrived, and in the field, living in tents. They are quite capable of replacing a full-fledged bed due to the presence of a velor cover, very pleasant to the touch. But, unfortunately, it often happens that holes appear on the surface, and we begin to look for the answer to the question of how to glue an Intex air mattress. Although sometimes it happens that a leaky thing is simply thrown away. But
how to glue an Intex
air mattress has been invented for a long time.
Materials for repair of an Intex air mattress
The company produces a special kit for repairing damaged products. It includes glue, patch material and transparent film. This procedure is very simple, takes a little time and can be performed even in field conditions. Some craftsmen, answering the question of how to seal the seam of an air mattress, suggest using ordinary superglue. But this will only help for a short time, then the mattress will again let air through, and re-sticking the patch will be more problematic.
Procedure for repairing an air mattress
If you find a hole or cut on the surface of the mattress, you need to clean the space around the villi of the velor coating in a radius of about 2 cm. This can be done with a solvent or nail polish remover. After applying the liquid to the surface to be cleaned, wait about two minutes, and then remove the adhesive layer with the blunt side of a knife or spoon. We perform this procedure until the surface is completely cleansed.
How to stick an air mattress?
In order for the mattress to serve after many years of repair, before applying the glue, it is necessary to thoroughly degrease the glued surfaces with acetone, a solvent, and if they are not (for example, in nature), alcohol should be used. At the place of tearing or cutting, put a transparent film, which is in the repair kit, and outline it, retreating 3-5 cm on each side. With transparent film, this is much easier.
After that, we cut out a similar patch of the same size from the material included in the repair kit. Place the cut on a flat surface (in nature it can just be a board), apply a patch and outline it with a pencil. This place is degreased once again: there will be no further questions about how to glue the Intex air mattress so that the patch does not lag behind. We apply a thin layer of glue on the patch and on the mattress with a brush, leave it for 15 minutes so that it dries out a little. We repeat the same procedure again, only the drying time is reduced to 5 minutes. In general, 15 minutes is a rather relative concept, because a lot depends on the ambient temperature, air humidity and other indicators. It is necessary that the glue sticks a little to the hand, but is dry. Before gluing the patch, it is necessary to heat the bonded surfaces a little. This can be done with a hair dryer. After heating, firmly press the patch to the mattress and iron it with a roller so that there are no air bubbles between them, lay the load on top and leave to dry for 24 hours.
That's the whole answer to the question of how to glue an Intex air mattress.