Probably every second person would like to have their own pool. And most owners of private houses have this opportunity. Many have become accustomed to the stereotype that such an idea requires a fairly large investment. But in fact, this is not entirely true. An excellent inexpensive solution would be to install a frame pool. This option is more than affordable. Even those who have a cottage near ponds do not always have the opportunity to swim. Since not everywhere there are clean ponds, but in the hot summer everyone wants to be able to cool off a bit in cool water.
In a traditional frame pool, steel components act as supporting walls. Above the parts should be a strong film, the necessary plastic sides and devices for filtering water.
Replacing water is very easy. At the bottom there is a special faucet, to which you need to bring a hose, dirty water will flow out of it. For the maximum benefit of this design, you can use the consumed water for irrigation of plants, vegetable garden or garden.
This article will provide general instructions for installing a frame pool. This work requires at least two people. The more people will participate in the construction, the faster and easier the expected result will appear. The pump should be installed at the end of the entire assembly. The pond should be placed on as even a surface as possible. It should not have any stones, knots, small cavities and other similar things, since all this can lead to damage to the material. It is better to keep the storage box; it can come in handy when reassembling and further storage in the winter. Installation of the frame pool "Intex" should take place on the litter. It is better to prepare the site in advance. Above it is the base of the pool (fabric). You need to pay attention to the direction of the drain hole, because in the future you will need to send water to the desired location.
The drain valve is removed from the hose and waiting for the heating of the fabric of the future design. Then you need to insert the beams into the passages intended for this. It is very important not to move the material on the ground, as fabric may be damaged. Therefore, the installation of the frame pool should immediately be carried out in the place of further use. The location of the reservoir should be at a distance of the full length of the elongated pump cable from the outlet (it is strictly not recommended to install a pool directly next to it). The horizontal beam must be inserted into the hole prepared for this, then connected to the T-joint using a bolt and rubber seals. Installation of the frame pool in this mode should take place in one direction. At the end of the alignment of the circuit, it may be difficult to connect parts. To do this, it is recommended to raise them by 5 cm and at the same time lower them, connecting at the same time.
There are many subtleties of assembly, and it is recommended that you observe all of them. The work may seem a little time-consuming, but the result will exceed all expectations. Reinstalling the frame pool should be confident and automatic. Today it is one of the optimal, inexpensive, but high-quality pool options.