Aqueous emulsion paint - a means for painting ceilings suitable just perfect. It does not cost too much, but it looks very neat. However, of course, the surface will look spectacular only if the required processing technologies are strictly observed. Further in the article, we will consider how to paint the ceiling with water-based paint without stains.
Causes of Stains
After this paint dries, various kinds of defects often appear on the ceiling. First of all, these are spots that are clearly visible at unequal angles or when using various light sources. Unfortunately, such a defect is considered difficult to repair. The fact is that when painting spots, the unevenness of the coating usually only intensifies, which exacerbates the situation. And therefore, with the appearance of such defects, the work on finishing the ceiling most often has to be performed anew. In order to avoid such a problem, the first step is to properly prepare for staining.
How to choose a roller
So, let's see how to paint the ceiling with water-based paint without stains. And first, let's figure out how to choose the right tool for this operation. The ceiling can only be carefully painted using a roller. The brush will leave streaks and small stains. For water-based paint, a long-nap roller is most suitable. With this tool, you can apply the composition as evenly as possible. Foam and velor rollers in this case are absolutely not suitable, because after them ugly “pores” can remain on the surface.
How to mix paint
Products such as water-based paints for interior use should be diluted exclusively according to the instructions on the label. In most cases, no more than 10% of water is allowed to be added to this type of paint. Otherwise, the composition will turn out to be very liquid, and it will not be possible to paint the ceilings. Water can be poured directly into a can of paint. Add it little by little, constantly mixing the composition. To perform the last operation, it is best to use an electric drill with a special nozzle.
How to color paint
Traditionally, ceilings are treated with white water-based emulsion. However, coatings with a light shade also look very impressive: pink, blue, green. Those who wish to arrange the ceiling in this way should definitely familiarize themselves with the rules for tinting the emulsion. They are as follows:
Choose a shade of paint should be in such lighting, which will be used in the room most often. In this case, it is worth using a special tinting card.
Add the selected color immediately to the entire amount necessary for the design of the ceilings in the apartment paint. Otherwise, the surface will necessarily turn out spotty.
Stir the color in the paint only with a drill and for quite some time - at least 10 minutes.
How to draw paint on a roller
How to apply a water emulsion to the ceiling, consider a little lower. Now, let's figure out what is the technology of recruiting the composition on the roller itself. Of course, in order to get the ceiling neat, this procedure should be performed correctly. The roller must be completely covered with paint. However, dipping it in a bucket as a whole, of course, is not worth it. Correctly applying paint to this tool is very simple. The roller should be slightly dipped in paint and rolled out on some hard surface. It can be, for example, a piece of plywood, linoleum or plastic. If necessary, the rolling procedure can be repeated twice.
Sometimes experienced painters act differently. In this case, a little paint is simply poured into the tray. Further, the roller is periodically rolled during the processing of the ceiling on a surface specially created for this purpose on it.
How to paint the ceiling with a water-based paint without stains and correctly
Of course, there is a certain technology of applying the composition to the surface. The roller itself should be taken quite wide. This will make it possible to work not only efficiently, but also quickly. You can finish the ceiling from a stepladder or from a high table.
Actually, the very answer to the question of how to paint the ceiling with a roller is simple. The basic rules for performing this procedure are as follows:
First of all, the perimeter of the room is painted over with a strip of approximately 10 cm wide. To perform this procedure, it is best to use the appropriate brush.
Rub the paint over the surface with a roller as thoroughly as possible. When painting, make sure that no drops remain on the ceiling.
In the course of processing it is necessary to peel off the ladder from time to time and inspect the surface from different angles. Thus, it is possible to achieve the most uniform coloring.
Apply water-based paints for internal work, usually in at least two layers. In this case, before painting the surface for the second time, they wait for the ceiling to completely dry. The emulsion dies quite quickly. Layers should be applied so that the first is perpendicular to the second. In this case, you get a more uniform design. Staining should be done so that the second layer is performed in the direction of the rays of light from the window.
What else you need to know
Water-based paint is an excellent answer to the question of how to paint the ceiling in the room. However, in order to get the most accurate surface, among other things, it is worth observing the following rules:
You need to buy only new paint. The old one may have a heterogeneous consistency.
Before painting, check the roller. The villi of this instrument should in no case be left behind.
Seams and unevenness on the ceiling before painting should be eliminated, and its surface should be primed.
Paint price
Of course, many apartment owners are also worried about how much it costs to paint the ceiling with a water emulsion. The price of this tool is really very low. So, for example, a can of 3 liters costs about 150-170 rubles. This amount is enough to process ceilings with an area of about 30 m 2 in one layer. Thus, no more than 2 three-liter cans or 300-400 rubles will be required to decorate the ceilings of a standard two-room Khrushchev.
So, we have figured out how to paint the ceiling with a water-based paint without stains. As you can see, this procedure is relatively simple. The main thing is to carry out the preparatory work correctly, choose a good tool and not violate the technology of applying the composition to the surface.