Building a bath is a very time-consuming process, which requires thorough preparation. It is very important to be guided by technological requirements, otherwise the bath will not be warm and reliable. If you thoroughly approach the question of how to build a bathhouse with your own hands from a beam, then you can create a whole park complex with flower beds and a pond on the site.
What should be considered during construction? First of all, you need to think about creating a pillar-base foundation. For this, concrete blocks are usually used. In order to
build a sauna from a bar, it is necessary to lay the blocks on a support. The distance from the ground in this case should be about twenty centimeters. If you plan to make a large bath complex, then you should lay four blocks on each side on a support. The distance from the ground in this case should reach about thirty centimeters. Naturally, it is necessary to pay attention to the soil and landscape of the place where the building will be located. It should be understood that under the blocks there should be a special pillow of sand and gravel, the thickness of which will be approximately equal to twenty centimeters.
So, all the excavation work is completed, the foundation is laid. Now we should talk in more detail about how to build a bathhouse with our own hands from a timber. First of all, it is necessary to lay on the base about two layers of roofing material. After that, you can start laying the first crown. Also at this stage, you will need to immediately lay down all the sex lags and outline the places on which the partitions will subsequently stand. In order to give the bath a fortress, it is necessary to cut logs from the timber under all future partitions. Under the floors, you need to put a board whose width is forty millimeters. When double strapping will be done, you will also need to put a beam. Thus, all the lags will be stacked on it, and not sip.
At the next stage of the search for the answer to the question of how to build a bathhouse with your own hands from a beam, you should begin to erect a log house. It is worth knowing that the wall thickness in this case should reach about 90 millimeters. The optimal height of the bath is 2.35 m. In total, in such a building there should be about seventeen crowns. The length of the nails that will be used for installation should be up to 200 millimeters. Remember: the hats should be sunk into the beam by about three centimeters. This must be done so that when laying the next crown, the nail does not create any obstacles. At the moment when the height of the log house reaches about 90 centimeters from the floor, it will be necessary to begin to cut through the window openings. Usually their height reaches 1.2 meters, and the width is one meter. It is also necessary to leave about six centimeters above the hole to be cut so that subsequently there are no distortions.
How to build a do-it-yourself bathhouse from a beam when this stage is completed? After the log house is done, it is necessary to proceed to the installation of rafters. For this, a simple board is usually used, the thickness of which reaches forty millimeters. Do not forget about laying the necessary insulation materials. Then it is necessary to nail the crate on the rafters and lay the roof on it.
After all roofing works are completed, you should proceed to the interior decoration. At this stage, you must first lay the rough floor, which subsequently will lay the glassine and insulation. After this, laying of the finished floor from the grooved board should be done . The ceiling must be nailed directly to the rafters. This must be done through glassine.
The question of how to build a bath yourself was considered. The only thing left is small - to correct minor flaws and make shelves, benches, stove and other necessary elements inherent in each such building.