Plastic windows instantly appealed to consumers right after they entered the market. Currently, almost no one is installing their classic wooden counterparts. Their advantage is that not only a professional with experience can mount them. After reading our article, you will learn how to properly install a plastic window. So let's get started.
When installing such double-glazed windows, there are the following nuances:
- You can install them even in winter. However, you yourself must understand that it is best to work in the warm season. In addition, in summer and spring, mounting foam cures better. So how to install a plastic window necessary according to all instructions, this process can take more than one day: living in an apartment blown by all the winds will not be too comfortable.
- The need for accurate measurements of window openings. The success of the whole event depends on the success of taking measurements.
If you want to install plastic windows cheaply (on your own) in a panel house, then you should also measure the internal opening. The fact is that in such cases, the box with the frames is held on the opening, the cross section of which resembles the letter āGā. Measurements are carried out according to the following instructions:
- measure the distance between the side slopes;
- measure the distance from the windowsill to the slope on both sides;
- note that the width of the window sill must be equal to the width of the wall, except for the width of the profile.
Before properly installing a plastic window in a
brick house, you should determine the load-bearing wall, since it usually has a thick layer of plaster on it. This should be taken into account when measuring window openings.
It is believed that it is easiest to install double-glazed windows in a wooden house, but this is not so. Keep in mind that wood is a whimsical material, it easily expands and contracts under the influence of environmental factors. Therefore, you need to install windows on a pigtail. This is an independent timber structure, similar to a door frame trim. Thanks to it, the window does not jam and does not deform due to the "movements" of the tree.
We repeat once again: since it is quite difficult to correctly install a plastic window, you must carefully follow the instructions.
- Pulling out the plugs, pull out the double-glazed windows themselves.
- Mark each of them, so as not to confuse during installation.
- Remove the protective film from the ends by sticking in its place a paper tape or other similar coating.
- Glue a vapor barrier film to the end of the plastic frame.
- Having installed the bearing blocks in the opening, put on them an assembled window.
- Carefully adjust it using the building level.
- Finally fix the box with metal profiles and fill the voids with high-quality foam.
- Install the windowsill, ebbs, and then carry out the installation of double-glazed windows. Fasten the plugs you need to start from above.
- Set the internal slopes, fix the decorative profile.
If you follow all our instructions exactly, you can quickly and efficiently install plastic windows (Moscow will impress anyone with their assortment). We wish you success!