For many, jeans are an important element of the wardrobe. But no matter how much money you give for them, sooner or later they will show signs of wear. Especially often jeans are rubbed between the legs. What to do, do you immediately throw such a pair? Not at all necessary, because this nuisance can be corrected and the life of jeans extended for several months, or even years.
Know the enemy in person
It is much easier to monitor the condition of jeans than to try to sew up rags on the loin. For example, look at the photo below.
There are two troubles here:
- The seam begins to spread.
- Jeans are rubbed between the legs.
What to do with such problems? First, you need to fix a bad seam. Otherwise, a very awkward moment can come when your pants crack. This can be done manually or on a typewriter. Sewing stores sell special strong threads for sewing denim, which are painted in popular colors for denim stitches.
Secondly, you need to gently darn those areas where the thread has worn out. To do this, select threads that not only match the color of the fabric, but have the same thickness.
Spread the fabric and, be sure to fasten the stitches in still tight areas, start making horizontal stitches over the hole. Insert the needle into the opposite edge of the gap. Then make a vertical stitch down and only then come back. This is necessary so that the threads do not mow or tighten the fabric.
After completing the horizontal row, begin work on the vertical, passing the needle between the threads. In fact, you will weave a new fabric over the old.
Repair for upcoming damage
This method can be used for minor damage. For example, there is still no hole, but already the jeans are worn between the legs. What to do? Need to strengthen the fabric as soon as possible. To do this, you need denim patches, fabric glue or hot-melt adhesive tape ("spider line").
Cover the area with bad cloth with tape, put a piece of denim on top and iron it with a heated iron. Such a patch is invisible, completely merges with the base, glue penetrates the structure of the fabric and strengthens it. If you have a high-quality "cobweb", then it will last a long time. The frequency of washing also affects its service life. Of course, if you additionally flash the patch of the patch, then it will hold on as long as you wear these jeans.
If you are lucky, you can find ready-made patches in sewing stores. They have one side made of denim, the other made of hot melt adhesive. They are attached to the fabric also with an iron.
But this method has a drawback - the patches should be small, as the fabric becomes harder, wrinkles worse and can cause discomfort if such a section occupies a large area.
Jeans rubbed between the legs. What to do?
The photo below reflects a picture familiar to many.
It would seem that this pair can be safely sent to the trash. What to do if jeans between the legs are worn, how to sew large holes quietly and accurately?
There are two ways:
- Machine darn. Manually it will be a long and painstaking process, while a special device will darn such a hole in 5 minutes. See photos before and after.
The machine literally recreated the structure of the fabric and strengthened the edges of the hole.
Of course, you have to go to a sewing studio, and the sooner the better the repair.
- Applying patches of fabric. This is a more budgetary method, because you can deal with it yourself (if you have a machine) or ask friends.
How to sew a patch
So, your jeans are rubbed between your legs. What if the hole is large?
1. Cut the protruding threads along the edges without touching the fabric itself.
2. Turn the jeans inside out and circle the hole, retreating from the edge of 2.5 cm. Ideally, the edges of the hole should be treated with an overlock, but then the patch will be more noticeable.
3. Cut the "cobwebs" or glutinous interlining of the desired area. Also come with denim for repairs. It is better to cut it diagonally from the weaving of threads. So the fabric will not crumble and sprawl. Or use ready-made patches.
4. Glue the non-woven and denim to the hole with the already heated iron. Lightly steam the patch, pay special attention to its edges. Wait for this area to cool.
5. Then sew the edges of the patches on the sewing machine.
Turn out the jeans and on the front side sew a new fabric diagonally. Zigzag stitch is perfect for this purpose.
6. Hide the ends of the threads and the repair is complete.
If you notice that the junction of the joints between the legs began to wear out, cover it with a patch, as shown in the following photo.
What should be done so that the jeans do not rub between the legs?
Often a problem is easier to prevent than to solve. Protect your favorite jeans from unhappy fate, take care of them and wear them correctly to avoid premature wear on the inside of your legs.
If the jeans are too tight or, conversely, too loose in the hips, then this leads to excessive friction, and in the future - to holes. Also, the lower the fit, the greater the load on the fabric in the thigh area and the more often the jeans are rubbed between the legs. What to do to avoid this annoying phenomenon? Buy models that fit and fit you well. Of course, denim stretches, but everything has its limits, so be sure to appraise your real size. Also check that there are no factory defects or scuffs on the pair that you are going to buy.
Proper washing
If you don’t read the care label, you don’t have to complain that the jeans are worn between your legs. What to do to denim successfully survived the cleaning?
Turn the jeans inside out and wash them separately or with two or three more pairs of jeans. No need to resort to this procedure unnecessarily. But it is also not worth neglecting (not only due to obvious factors), because particles of dirt and dust act as small abrasives when moving, tear the fabric threads.
Wash your jeans delicately with cold or warm water, avoid using hot water or bleach that weakens your denim.
Machine drying also leads to the fact that the jeans are rubbed between the legs. What to do to minimize harm after washing? Instead of throwing your pants in the dryer, it is better to hang them in the bathroom or on the balcony in the old fashioned way and patiently wait until they dry.
Now you know what to do so that the jeans do not rub between the legs, and you can significantly extend their service life.
Sport and Denim
A bicycle is the worst enemy of jeans. Frequent and uniform up-down movements, accompanied by friction on the edge of the saddle, destroy the fabric very quickly. Therefore, cyclists constantly rub jeans between their legs. What to do in this case? If you regularly ride in jeans, then you have to come to terms with future holes and immediately put the latches in problem areas. Better yet, get a pair of trousers designed for cycling. And it can also be jeans, but specially made for such an operation, for example, Levi's 505 Commuter or Cadence Raw Denim Jeans. They have double or padded fabric on the seat.
Nothing is eternal
If the jeans are worn between the legs, what to do with them - you already know. But there will come a time when they will have to be thrown away, no matter how you try to move it away.
True, the Dutchman Ari Vandenberg for 8 years socks lovingly darned and patched his jeans from Levi's.
After that, they not only completely lost their resemblance to the original, but even attracted the attention of fashion magazines and won the competition from the clothing store famous in Amsterdam. And for Ari, they became, to some extent, the embodiment of part of his life's journey. A suitable role for real jeans, isn't it?