Putty on wood is used to correct a variety of bumps on wooden surfaces in the interior areas of the room. This material has found wide application. Putty poorly passes moisture, which provides effective surface protection, and this will allow it to operate much longer. If a place is patched up in this way, it can be easily painted or varnished. It allows you to get rid of small cracks, knots, as well as other defective elements. After the putty on the wood dries, it takes on the same color as the wood itself. It is used for furniture, ceilings, wooden doors, walls, floors and other surfaces.
Putty on wood
for the floor has good adhesive properties, dries quickly and fills the gaps perfectly. Dust accumulation can be reduced by varnishing. To use this
type of putty, it needs to be mixed with wood dust, and to minimize clogging, the joints should be varnished after varnishing.
Recently, more and more often used
acrylic putty for wood. It is usually recommended for parquet. The surface to be treated must be dry, durable and clean. It should be stored in a container closed with a sealed lid. It will be able to survive longer if as little air as possible gets into it. The shelf life of this
type of putty is 12 months.
To give the floor the highest class, it must be carefully prepared for painting. Putty on wood will provide the necessary properties. The wax layer on the floor prevents the paint from drying out quickly, for this it needs to be washed with warm soapy water. After drying, it can be putty. Only then can you varnish or paint the
wooden floor. If you comply with all these requirements to the maximum, then the floor will serve for a long time without losing its original appearance.
Wood putty can be bought at any hardware store. Since it is used widely enough, there should not be a problem with its acquisition.
The putty should be attached to the primed surface in a quality manner, be of high quality, because after drying it will need to be sanded. With low quality material, it will crack and crumble, and this is highly undesirable. In addition, the material should be well applied by spraying or with a spatula, have a uniform composition without any mechanical impurities.
Depending on what method of putting putty is supposed, its consistency can be liquid or pasty. The second type is used for continuous coating of the entire surface. The surface must be primed before applying putty. The work is carried out exclusively with a clean spatula, the only way to get a thin even layer. After that, the entire tool should be thoroughly washed, since the spatulas become unusable due to the dried putty.
When the surface dries, it will need to be sanded.