The heating system of a private house should be thought out as thoroughly as possible even at the construction stage, so that many associated problems can be avoided. This will be very beneficial when the installation of heating pipes and a boiler room begins. Technical niches for different needs should be provided, a separate room should be reserved for the boiler room, if there is any need for this.
Installation of
heating pipes and systems in general can only begin if the roof and windows are already installed. At the moment, it is customary to lay them by the method of hidden wiring, that is, using shtrobov or directly in the floor.
Laying pipes in the screed is the most appropriate, but if this is not possible, you can lay them directly in the walls. This method is used quite often on the second floors, where the floors are wooden. It turns out that the
installation of heating
pipes is best done while the screed is not yet filled, but the walls are already plastered. If you place the radiators before the plaster, then you will need to align them later. In some cases, all installation operations are performed in two stages: first, the pipe outlets are made with a margin, and then radiators that are connected after the plaster are hung. With this method, it will take much more time to work.
A certain technology should be followed. First you need to hang all the radiators, outline the boundaries of the strobe for the findings, and then stash. When this is done, put the radiators in their places, make the heating pipes, and then connect them. In places of withdrawal, they must be fixed with cement mortar or alabaster. When everything hardens, it will be possible to remove the radiators. They should be folded away from the places of finishing work. If this is not done, then the film will not save them from damage and dirt.
You can make a hidden wiring even when the house has already finished decoration. Installation of heating pipes can be done down along the walls, placing them in a special box. This layout is called skirting. Some Western manufacturers offer ready-made skirting boards for heating, which has ready-made materials and components. However, it can be done independently. This is done using a plastic box, which is similar to the one used for electrical wires.
Installation of heating system: pipes
If tee wiring is used, it is better to run pipes along the walls. However, it is worth leaving an indentation of about 150 millimeters, which will help to avoid damage to them when you start nailing skirting boards. Modern systems do not imply any kind of bias towards the cranes, since this is no longer necessary. However, the installation of heating pipes should still be made subject to certain rules. It is important to ensure that air traffic jams, that is, some humps, cannot form in them. If this cannot be avoided, then a special valve should be installed at the upper point for venting.
You can use plastic pipes for heating, the installation of which is not particularly difficult, but you can also other options available to you.