"Vetonit 3000", the technical characteristics, the consumption of which you should be aware of before purchasing, is an ideal mixture for leveling floors in rooms for various purposes, whether it be public, office or living rooms.
general description
The above composition is used when necessary repairs and new construction on cement-sand and concrete substrates. With this mixture you can get an excellent base on which any floor coverings can then be laid. The material can be used as a finishing layer for screeds, which were arranged with the introduction of a heating system. The mixture is suitable for manual application, and it can be used both in dry and in wet rooms. The main condition is the ability to conduct exclusively internal work.
Key Specifications
"Vetonit 3000", the technical characteristics, the flow rate of which is mentioned below, allows you to get a perfectly flat floor, which is suitable for any, even the thinnest floor coverings. Masters note low consumption and profitability, as well as a short drying period. You can move on the surface after 4 hours, and you can lay the finish coating after three days. The composition after mixing easily spreads, and also does not imply that the master has professional skills. Such a coating is able to undergo increased abrasion and mechanical stress, and furniture items equipped with wheels can also be attributed to this.
Key Features
"Vetonit 3000", technical characteristics, the flow rate of which is mentioned in the article, is gray, has water resistance, and special cements are used as binders. Limestone acts as a filler, as for the fraction, it is less than 0.3 millimeters. One kilogram square will take 1.5 kilograms of the mixture. Using "Vetonit 3000", technical characteristics, the consumption of which you can find out by reading the article, you should provide a layer thickness of 0 - 5 millimeters. Operating temperature varies from plus 10 to plus 25 degrees, this feature must be taken into account. Water consumption per kilogram will range from 0.26 to 0.28 liters. It is recommended to use the composition after cooking within 30 minutes.
Packing and storage
Vetonit 3000, the technical characteristics of which were described above, is packed in three-layer paper bags, the middle layer of which is polyethylene. The capacity of one bag is 25 kilograms. On the pallet fits 48 bags, which is 1200 kilograms. It is recommended to store the composition after the manufacturing date for 6 months, but not more. At the same time, it is important to comply with conditions that require the preservation of factory packaging and a dry room.
Foundation preparation
If you will use Vetonit 3000, the technical characteristics of which are quite impressive, then you should know how to properly prepare the floor surface. If you have to work with a base whose top layer is quite weak, then you should get rid of it by grinding. It is important to clean the floor of greasy stains, glue and old paint. The mixture is applied solely on even surfaces where all holes, cracks and places where the material may leak have been sealed in advance. If the rough base has irregularities of more than 5 millimeters, then pouring should not be done. The base is pre-cleaned with a construction vacuum cleaner and treated with a primer.
The nuances of training
"Vetonit 3000", technical characteristics, analogues of which are presented in the article, should be applied to a substrate that is not excessively porous or dry. Before starting to distribute the bulk floor, the surface should be primed twice, which will save the solution. If the surface is treated with a dispersion composition, then Vetonit 3000 will adhere to the base better. This technology eliminates the occurrence of bubbles.
Solution preparation
If you still can’t decide which mixture to choose for the bulk floor device , then you can pay attention to analogues, among them consumers quite often choose the manufacturers “Ceresit”, Ivsil and “Horizon”. The technology for using each of the mixtures is the same. The dry composition is poured into a clean bucket, then filled with water. Stirring is recommended to be done with a construction mixer until a homogeneous mass can be achieved. If the mixture is too thick, you can add some water. This will not damage the quality of the material and will achieve the desired effect.