Fecal pumps for dirty water are represented by two modifications: the first is for cold drains, the temperature of which does not exceed 40 degrees, while the second is for hot, and the temperature level should not rise above 95 degrees.
Consumer Reviews
The main advantage of the described systems is that they are not afraid of solid debris, pebbles that can disable a high-quality drainage pump. On the site, it is often necessary to pump out not only sewage. On the territory of a country house, it may be necessary to service storm sewers, as well as eliminate spring floods in the basements. Sewage pumps for dirty water are used and if it is necessary to drain the pool for the winter, as well as watering the garden, this multifunctionality is very popular with modern customers.
One stop solution
In order not to buy a separate device for each task, it is recommended to purchase a fecal pump. With its help it is possible to pump out not only clean, but also dirty water, as well as that which was clogged with silt, household waste and sand. Of course, for pumping drinking water from a well and a well, such a device should not be used for hygienic reasons, however, all domestic needs that may be associated with the supply or pumping of household water can easily be solved by the owner of such a device.
If you look at the store for sewage pumps for dirty water, then, according to users, it is best to prefer models that are equipped with grinders. This indicates that semi-submersible systems should not be considered, because they very rarely install a cutting mechanism.
Technical characteristics of surface and submersible pumps
Deep sewage pumps for dirty water are most often supplied with shredders, as they are located inside the drains and when sucked near the inlet, they can dissect any debris. As for surface models, only one hose will be located inside the drains, the equipment itself will be installed near the cesspool. It is clear that the garbage is initially transported through a hose, only after it will be shredded at the exit.
The first option is considered more practical, since you will not encounter such a problem as a clogged hose. If a comparison is made between these units according to the criterion of design complexity, it is much simpler to connect surface sewage pumps for dirty water, this also applies to dismantling equipment after pumping sewage, the hose can be immediately removed from the water, and then washed and stored.
Submersible Pump Operating Instructions
With a submersible pump, the situation is somewhat different and more complicated. The device must be lowered with a cable, fixed on steel reinforcement, and then dismantled, which involves complete cleaning of the unit, all this cannot be called a pleasant procedure. However, during operation, this device will not make noise, and the external pump is able to attract attention with its actions.
If you are going to choose a fecal pump for dirty water, then it is worth considering that when buying a submersible option, you will need to stock up with sufficiently strong cables and think carefully about the technique of lifting the device to the surface, which may be needed for maintenance.
Waterproofing Specifications
A fecal pump, the average price of which is 4000 rubles, can be purchased by you in the store of the corresponding goods. If the pump is designed to work on the surface, then it is not provided with waterproofing in a factory. This suggests that fog, rain and snow are strictly contraindicated for the device. When pumping effluents in the winter, there is a possibility of freezing water inside if the temperature drops below zero. This may cause the device to malfunction.
That is why for a house where the owners live permanently, the outdoor option cannot be called too convenient. However, in the country, where they live only in warm weather, such a model will become an indispensable assistant. Before the onset of cold weather, the owners, as a rule, pump out the sumps, and then lay the system for storage in the house until the beginning of the next season.
Submersible pump protection
If you were faced with the choice of a fecal pump for dirty water, then you may prefer the submersible option. By the degree of waterproofing, as well as resistance to aggressive environments, such devices are beyond competition. The manufacturer indicates that the device is designed for a ten-year service life of uninterrupted operation, while the use will occur in sewage conditions without dismantling. Thus, you can purchase such a unit only for sewage, install it in a cesspool and completely forget about it. Automation will be triggered after the level of sewage is above a critical level. As soon as everything is pumped out, the system will shut down.
Such sewage pumps for dirty water, reviews of which, as a rule, are the most positive, suggest the need to equip a sump system into which the equipment will pump sewage. If you dump the hose off-site into a ditch, into a forest or onto a road, then the neighbors will inform the appropriate authorities.
When you should not choose a submersible pump, or the weaknesses of submersible models
The deep fecal pump, the price of which is mentioned above, has a negative feature, which is expressed in the complexity that arises when dismantling is necessary. If you periodically have questions about pumping water from the pond, watering the garden or draining the sumps, you will have to wash the casing each time, and then dry it. Such systems are made using very durable cast iron, plastic or stainless steel, but you need to take care of such a device, like any other household appliance.
Instructions for choosing a device depending on the power
If you are interested in drainage fecal pumps for dirty water, then you should definitely pay attention to such a factor as the power of the device, the lifetime of the device will depend on this. If you use the equipment all year round, and also carry out pumping every month, then the surface type system is not suitable for this. Submersible options can have completely different power, 40 kilowatts act as the maximum value. This force is enough to raise the contaminated liquid to a height of 20 meters.
Thus, they are suitable for deep cesspools. If you are considering surface sewage pumps for dirty water, it is important to calculate the capacity for specific needs. In this case, it is worth considering the depth of the cesspool, as well as the distance to the place where sewage will come. For example, if a septic tank has a depth equivalent to 8 meters, the hose is needed for 30 meters, then you need to make the following calculations: the depth must be added to the length of the hose, and then divided by 10. The final value is 11 meters.