A chevron is a graphic sign (image) that resembles the Latin letter V, rotated by various sides. In this article we will find out how to sew chevrons on a tunic without errors. It is known that in the army and other formations for a long time there are insignia. Previously, the “emblems” for the soldiers were tattoos with which they adorned their bodies. The first chevrons appeared in the Middle Ages: they denoted the status of the owner and his belonging to a particular service. Of course, the military did not always know how to fasten stripes on uniform.
Historical standards
So, we will figure out how to properly sew chevrons on a tunic. Based on history, the element usually belongs to the military circle. But it also finds application in overalls of various enterprises, the uniform of security officers and law enforcement agencies. If you need to sew a chevron on a military uniform , then you need to act according to certain standards. These graphic signs are stitched in a special way to specific places - this is, most often, the left sleeve of a tunic.
We answer the question of how to sew chevrons on a tunic. If there is a pocket on the sleeve, the image is attached at a distance of two fingers from its lower edge. Of course, operating a thread and a needle in this case is very difficult, but the result will exceed your expectations!
Technology
The technology of attaching a graphic sign to a sleeve is simple, but it requires some skill. First you need to measure the necessary interval from the upper seam of the sleeve, then place the chevron in the place intended for it. Next, with the usual pin or needle, the upper point of the mark must be attached to the fabric of the sleeve. This point should be placed in the middle, if its width is meant.
In fact, how to sew chevrons on a tunic, every soldier should know from the first days of service. But we study the technology further ... Now we put on a tunic and become the corresponding side in front of the mirror. We place the lower edge of the chevron on a freely lowered hand so that the sign is held on the sleeve without distortion, strictly vertically. The second needle needs to attach the lower edge of the patch to the intended place.
Next, the tunic must be carefully removed and with small stitches hidden inside, sew the image along the contour. At the same time, the chevron should not form folds. Try to keep it tight against the sleeve. Of course, the color of the threads should match the colors of the patch fabric.
rules
Agree, how to sew chevrons on a tunic, few know. There are strict rules here. Information can be found in Order No. 300 of June 22, 2015. On the front of the left sleeve there should be a sign of belonging to the General Staff, the Ministry of Defense, the Rear of the Armed Forces, the arms and branches of the Armed Forces, the Railway Troops.
Now let's find out how to sew a chevron on a military tunic. On the front side of the right sleeve is usually placed a sign of belonging to the fleets or military districts, special services and troops, specific military units. It should be noted that no more than one image is attached to the sleeve!
In general, chevrons (sleeve) will have to be sewn to those who wear:
- woolen tunic;
- flannel;
- woolen jackets;
- demi-season jackets (except senior officers);
- woolen cardigans;
- casual winter jackets;
- jackets for everyday suits;
- casual demi-season jackets;
- field jackets (except for water and windproof suits).
Breast Chevrons grind:
- to field jackets (except for waterproof and windproof suits);
- to jackets of everyday suits.
It must be remembered that the name patch is located on the left side of the chest, and the Chevron "Armed Forces of Russia" is on the right.
Police uniform
And how to sew chevrons on a tunic to police officers? Graphic signs attesting to belonging to the Ministry of Internal Affairs of Russia are stitched to the left sleeve at a distance of 80 mm from the upper edge of the image to the shoulder. Other chevrons are mounted on the right sleeve with the same interval.
The rules for sewing on chevrons of the Ministry of Internal Affairs are described in the order of the Ministry of Internal Affairs of the Russian Federation of July 26, 2013 No. 575. So, graphic signs are sewn onto the police uniform in the following order:
- The aviation division does not wear sleeve insignia.
- On camouflage sleeve signs are not sewn.
- If the policeman has a special rank, he places patches on the left shelf of the suit and back.
- Employees of the combat units of the traffic police. At DPS traffic police, the chevron is sewn on the left shelf of the suit, and for reflective materials, Police and DPS, on the back.
- Employees of special forces (OMON and SOBR) sew patches on jackets.
Representatives of dean's offices know how to sew chevrons on the FSSP tunic , that they acted as experts, creating instructions on this issue. In fact, such signs are attached to the tunic in the same way as the designations of the Ministry of Internal Affairs. By the way, students and cadets of specialized educational institutions wear rectangular stripes corresponding to the curriculum (“courseworks”). They are placed on the left sleeve of the form: from the shoulder to the upper point, a distance of 20 cm must be observed.
Chevrons Chest
The lapel image of the police wears:
- On vests, raincoats, jackets. The chevron is attached with a pin to the left breast pocket.
- On sweaters, blouses, jumpers, shirts. The patch is connected to the flap of the left breast pocket with a pin or folding button fastener.
- On a tunic. The sign is attached with a hairpin to the chest on the left where the ribbons of the orders should be placed or 1 cm below them.
- On raincoats, woolen jackets, coats. The image is attached with a hairpin on the chest on the left 8 cm below the lapel ledge.
- On a sheepskin coat or jacket. The chevron is fastened with a pin 4 cm below the "Police" sign on the left chest area.
FSIN
And now we will answer the question of how to sew chevrons on the FSIN tunic. In general, this is described in detail in the order of the Ministry of Justice of the Russian Federation dated November 8, 2007 No. 211 “On approval of the description of the form of employees of the executive-criminal system and the rules for wearing it.”
So, the chevron of the penal correction system employees is attached to the front side of the right sleeve, and the employees of the central structure of the Federal Penitentiary Service of Russia - to the front side of the left. Further, the graphic sign of the employees of the territorial bodies of the penal correction system is attached to the outer part of the left sleeve, the sign of employees of institutions is located there. By the way, the patch, the placement of which was not indicated above, FSIN workers must sew on the left sleeve. The breastplate, as well as the badges, are worn on the right chest by the employees of the Russian Ministry of Justice and the Federal Penitentiary Service. They are placed after the distinction received at the end of professional educational institutions.
And yet, how to sew chevrons on FSIN tunic? Chevrons are located on it so that the top layer is below the level of the corner of the lapel by 70 mm, and in the presence of a class mark or medals (orders) - 10 mm below them. By the way, the interval from the upper edge of the FSIN patch to the shoulder seam should be 8 cm.
FSB
Few know how to sew a chevron on an FSB tunic. We will clarify this difficult question. The placement of marks on the uniform is described in Order No. 413 “On the Military Uniform of Clothing of Employees of the FSB”. A sign indicating a connection with the organs is stitched to the outside of the left sleeve. The top point of the chevron should be placed at a distance of 80 mm from the shoulder seam. On camouflage, the sign is sewn in the center of the pocket located on the sleeve. An emblem indicating a relationship with a particular unit is placed on the right sleeve.
And the chevrons of the duty services and forces sew on the left side of the chest, stepping back from the ribbon of orders down 10 mm or in their place.
Hot issues
So, which side is the chevron attached to? The common mark is sharpened on the left, and on the right - a chevron, indicating a specific garrison. When talking about the Ministry of Emergencies or the Ministry of Internal Affairs, the general image is attached to the left sleeve, the symbolism of a particular unit is on the right.
How to sew a chevron on a soldier’s tunic, many readers already guess. The sleeve insignia is traditionally attached at a distance of 8 cm from the top of the insignia to the shoulder seam. Here experienced servicemen usually use a “hidden” seam. So you can sew a chevron in a good way: and the threads will not stick out, and the general appearance of the form will not deteriorate. As we see, we not only established how to sew the chevron (Russia) on the tunic, but also determined the places where it should be placed. There are sleeve symbols that fasten either at a distance of 8 cm from the shoulder seam, or in the center of the pocket located on the sleeve. There are chevrons that are located in the center of the chest pocket.
The graphic mark of the military branch is on the left sleeve, and the division mark is on the right. Chevrons are attached to both sleeves. On the left is usually a patch of the type and type of troops, on the right - a sign of a particular unit. The image is always stitched from the outside. Breastplates are located at a distance of 5 mm. In general, chevrons can be sewn onto the sleeve, chest and back. By the way, the general patch of the Ministry of Internal Affairs is on the left, and the sign of the private unit is on the right. We hope that having studied our article, you can always correctly grind chevrons on a tunic.