Strong popularity among consumers has recently been won by such building material as corrugated board. It is readily used for fencing sites, the construction of storage facilities and roofing. It is also in demand among car owners for the construction of garages. To build a garage from corrugated board with your own hands, you do not need large material costs, in addition, the profile is easy to assemble, it is durable and wins outwardly due to a wide variety of colors. Sheets of a metal profile coated with a polymer composition last up to forty-five years; they do not need constant coloring and special care.
It is necessary to start building a garage from corrugated board with your own foundation. It can be tape or columnar.
The floor in the garage is made concrete, with the simultaneous installation of a viewing hole. The basis of the construction is a
metal frame, the supports of which are installed at the time of laying the foundation and at the same time it is poured with concrete. After the supports are installed around the entire perimeter of the future garage, transverse pipes are screwed to them with screws. Sheets of corrugated board are attached to the frame with self-tapping screws, and the correctness of their installation is checked using the level. In order not to scratch the profile sheets, rubber gaskets are placed under the screws, and to improve the tightness, the joints of the flooring sheets are fixed with rivets. The distance between the racks of the frame should be equal to the width of the metal sheet, which will greatly simplify the installation and save from unnecessary work on cutting the profile. The garage from corrugated board is often insulated with mineral wool. You can use other insulation.
A self-built garage from corrugated board involves the installation of a single or
gable roof. The simplest, and therefore often used, is a
shed roof. Sheets from a metal profile are attached to the rafters from a corner or pipes, which are fixed simultaneously with the frame, with metal screws. After laying the profile, all joints are sealed with sealant.
Do-it-yourself garage is built quickly enough, this is within the power of almost every car owner. One or two assistants are enough - and in a couple of days the garage will be ready.
As already mentioned, corrugated board is very popular for the construction of fences, and since there is a fence, then you need a gate and a gate. Do-it-yourself wicket gate is mounted on supporting poles, which can be made of metal pipes or bricks. Pipes are installed in a pit not less than one meter deep and poured with concrete. If the pillars are brick, then an easy foundation is made under them. After installing the supports from the pipes or the corner, the wicket frame is welded in according to the predetermined dimensions. A pipe is welded into the middle of the frame. Awnings are welded to the finished frame, as well as to poles and supports, and a lock crashes into the frame itself. The corrugated board is attached to the finished frame with self-tapping screws, and a hole is cut out in the place where the lock is installed. After installing the door handle, the gate is hung on the support to check its operation.