A do-it-yourself carriage for circular circulars is quite often made by novice craftsmen and specialists. This element is an indispensable tool in the workshop. Using it, it is quite fast and safe to carry out precise cutting of the workpiece, eliminating the likelihood of reverse recoil.
Recommendations for work
If you will do the carriage for the circular with your own hands, then you need to choose the size of the base of the slide, their parameters should be equal to the size of the circular table. For emphasis, one of which is located at the back, the other at the front, it is necessary to use wood with straight fibers, such as cherry or maple.
The material should be moderately dense. It is important to make sure that the stops have perpendicular edges, and their length must match the width of the base. When the do-it-yourself carriage is made for the circular, it is important to ensure that the rear and front stops have magnification at the point where the saw blade passes.
The band saw will allow you to round the sides of the stops for convenience and weight reduction. To perform the guide bar, it is necessary to use hardwood, since it is quite dense. The size of the plank should be equal to the parameters of the groove in the circular table. Given the dimensions of the saw blade, it will be necessary to perform a protective cover, and then round the near corner.
Assembly wizard recommendations
When a do-it-yourself carriage is made for the circular, it is important to remember that the protective casing should not act as a handle; it should not be operated when the slide moves. For assembly, the back gauge is attached to the base, and in the lower part it is necessary to drill holes for installing screws.
In the groove of the circular table, you must install a guide bar, which is pre-treated with a layer of glue. The base should be placed perpendicular to the saw blade on the guide bar, it is necessary to leave the element in this state until completely dry. At the next stage, you need to take a few screws to strengthen the guide bar.
Conclusion
You can make a carriage for circulars with your own hands, a photo of which you can see in the article. After completing all the above work, it is necessary to turn the base so that the grooves on the circular table coincide. If necessary, you can additionally use sandpaper or a scraper to remove excess wood.