Drywall sheet is considered one of those materials that are excellent for creating a beautiful room interior. Cutting it is quite simple, but if it is necessary to carry out curly clipping, then it is very difficult to do it in the classical way, it will take a lot of time. In such cases, the most commonly used cutter for drywall.
Pros and cons
There are many advantages to this method of cutting, however, the following few points stand out among them:
- significantly reduces the time that you have to spend on work;
- the edges of the sheet are more even than with the manual method;
- the cutting angle, as well as the recesses, can be very different.
However, like any other way of working, there are some negative aspects to this.
- You will have to spend money on the purchase of milling equipment, as well as on a set of mills.
- During cutting, the surrounding air will be heavily contaminated with dust from the material.
- It is very important to choose the right nozzle for a specific case.
Varieties of cutters
For a specific case, a special cutter for drywall is also used.
Grooving direct equipment. Great for creating grooves and holes that should be placed at right angles to the sheet.
A grooved T-shaped cutter is used in approximately the same cases as a straight, but with the only difference being that with its help it is possible to make the largest possible holes in the sheet.
There is a cutter for drywall, which is called the edge nozzle. It is used only in cases where there is a need for chamfering from the edge of the sheet.
A U-shaped fillet grooving cutter is used in cases where you need to create a semicircular cutout in the slab.
There is a V-shaped cutter for drywall. Its feature is that it allows you to cut corners at 90 degrees, and is also suitable for cutting triangular grooves.
If there is a constant need for processing drywall boards, then the master should have them all at hand. If a person acquires them for homework and does not use them often, then the V-shaped will be the main nozzle.
Nozzle application
Using a do-it-yourself milling cutter for a V-shaped drywall is quite simple. That is why it is common among home craftsmen, and joining plates with right angles to each other is quite simple. The advantage of using such a cutter is also that the edges of all the plates will ideally fit each other. This will avoid any edge processing during repairs.
A cutter for drywall of this form opens up wide possibilities for curly cutting, which, for example, cannot be provided by a direct disk cutter. In addition, the use of this equipment will save a lot of time if you need to equip the interior of the room with such material. However, to buy a cutter for drywall is not all. It is very important that you familiarize yourself with the rules for operating the equipment. With the help of such a nozzle, even U-shaped boxes can be made, for example.