Any room, regardless of its purpose, requires periodic repair. Laying electrical wiring is a very important stage of construction and repair work, so before you start chipping surfaces, it is worth coordinating several important issues with family members, the designer, clarifying the established standards and the possibility of implementing the desired requirements in practice.
Regulations
The location of lamps, chandeliers, sockets, switches should be agreed in advance with those people who make the design part of the room and participate in their daily use. In addition, the contracting authority must have a permit, which is issued by the relevant authorities, since the construction documentation contains standards that cannot be violated during construction work related to wall breaking.
How to conduct wiring in the house, if its walls are concrete? Monolithic construction technology and brickwork, the thickness of which exceeds 30 cm, allow for gating. In a panel house, such work is prohibited. But users have the opportunity to replace the electrical wiring on the dashboards or plastic boxes available in the panels.
Hammer drill
Strobing of surfaces can be carried out with various construction tools. When working with brick and concrete walls, specialists use a punch, but before starting work, they make markings.
The marking of the wiring route is performed after the complete approval of the location of the end devices. Strobing for wiring occurs by drilling holes, the pitch of which does not exceed 2 cm, and connecting them by switching the hammer to the “hammer” mode. Partitions are removed at an angle of 90 ° with respect to the axis of the resulting holes.
Specialists, before stretching the cable, install switches, boxes under sockets. This is followed by the stage of closing the gate.
Bulgarian
How to conduct wiring in the house, if there is only a grinder from construction tools? It is necessary to take care of the presence of a diamond disk. In tandem, a construction tool is obtained, with proper use of which you can trace the route for wiring. But without a punch in this case, nothing will work.
Before starting work, the surface needs to be plastered. Shtroblenie surfaces occurs on previously marked tracks. Furrows are cut through the grinder, and a section of the wall located between them is removed with a hammer in the “hammer” mode. Using this method, you can get smooth, high-quality edges.
Stroborez
Chipping surfaces with this tool is the best method for obtaining high-quality results in a short time without dust. A high level of strobe reduces the cost of additional work.
Compared to a puncher and grinder, physical effort is minimal when using a chipper. This tool in tandem with an industrial vacuum cleaner allows you to perform high-quality gating. The price of services (and this, as a rule, is 1 dollar per meter completed strobe) ceases to interest customers, after they learn that all work will be carried out without dust and debris. The professional tool is equipped with a pair of diamond blades, thanks to this you can immediately cut both lines. The width and depth of the strobe are set independently, depending on the required and permissible standards, parameters.
Professional equipment of this kind should be used by qualified professionals. The quality of the work performed and the safety of its implementation depend on this.
Final stage
After the gating process is completed, the wire is laid, the final stage of replacing the wiring begins . Putty shtrob - no less crucial stage. Professionals in their field know the intricacies of this stage, but not everyone treats it conscientiously. If the customer controls the entire process, he must pay particular attention to what layer of putty is applied. Qualified specialists apply it in thin layers and wait for complete drying before applying the next layer. This happens until the thickness of the material is equal to the surface level.
The first sign that the requirement for complete drying of the layers was not observed is the roughness of the surface of the strob. The color of the dry putty should be identical to the shade of the wall. When gluing the walls with wallpaper, you will not see the places in which the gates were previously. If the color of the wall and the putty strobe is different, through thin wallpaper this will be noticeable.
Only the experience of a specialist determines the result. Surface chipping is a very laborious and responsible process that can only be performed by a professional in a quality manner. In matters of replacing the wiring, no errors should be made, otherwise they can lead to disastrous consequences.