Every gardener, owner of large agricultural land will not be able to get a healthy and rich harvest without adequate watering. That is why having a well in your area is everyone's cherished dream. To be able to get water freely and unhindered, you need to know how to drill a well. This can be done independently, if the occurrence of water layers is at a depth of not more than 10 meters, and this will not take you much time and labor.
To help you solve your question, how to drill a well for water, come the pump for drilling "Baby". Once you reach the required depth, this pump is able to pump water.
Consider the drilling process itself. To perform such work, you will need a steel pipe, the diameter of which must be no less than 120 mm. This pipe will subsequently serve to lift water from the bowels of the earth. Its length is determined depending on how deep the water artery passes.
Before drilling a well, some work needs to be done. It is required to weld several (4 pieces) ears to the pipe, to which a flange will subsequently be attached. The ears should have holes for the M10 bolts. A flange equipped with a straight fitting must cover the top of the pipe.
The pipe must be installed in a vertical position, and then lowered directly into the well. With the help of "Baby", water will flow into it under pressure. It should be noted that the teeth are cut from the lower end of the pipe. The process of access to water is as follows. Pressure pumps water, which enters the pipe and exits its lower part. Water has a leaching effect on the earth. The pipe with its weight is pressed into the ground, gradually descending into the deeper layers of the earth and reaching the level where the water layer lies.
You can make a collar for easy rotation of the pipe. For this, two tubes will be used, which are fixed with a tightening clamp.
How to drill a well for water? Paradoxically, for this we need water. Prepare a large, 200 L barrel. So that the pipe can be loaded faster and easier, it must be slightly rocked and turned from side to side. The teeth will crumble the soil, and small particles will be easily washed with water.
How to drill a water well quickly? This process is desirable to perform together. Decide on the place where your future source will be located or where the groundwater is closer. Now you are close to solving the question of how to drill a well? Manually dig a small hole about 1 m deep. We insert the end of the pipe with teeth into it. We deepen the pipe with the help of our collar, since it will be more stable in this way. We fix it well in an upright position. We turn on the pump "Kid". The water that will accumulate in the pit is scooped up and poured back into the barrel. It must first be filtered so that the pump does not burn out.
Now you know the principle of how to drill a well. To drill it to a depth of about 5 - 6 meters in loamy soils, you need only about one hour.
As soon as you descend to the water artery, it is necessary to remove the flange from the pipe. Next, lower the “Baby” pump into the pipe and make a test injection of water. The first portion will not be clean, but it is natural. During operation of the pump, do not forget to ensure that it does not lie at the bottom of the well, otherwise it will clog up with earth and its power will decrease.
How to drill a well manually is tedious, of course, but there are several ways, of which there are simpler ones. Here is one of them. Dig a pit, then set a derrick and a drill rod over it. Using the hoist, lower the bar into the dug hole. Start to rotate. To do this, you will need assistants, at least one. A certain mark on the bar should be noted, upon reaching which the bar is pulled out and cleaned of the ground. How to drill a well is not such a difficult problem. Enough reliable equipment and faithful helpers.