Step-by-step instructions on how to wind fishing line onto a trim reel

With the advent of spring, you often spend your time in the country or in a personal plot. A trimmer will protect you from a problem like grass and weeds. This tool easily trims and mows grass in difficult areas where an ordinary lawnmower can’t do it. The trimmer is a very effective and convenient tool for mowing grass along fences, flower beds, houses and aisles in the garden. Invented several types of garden trimmer (gasoline, electric and battery). It would seem that everything is fine, in your arsenal

l such a wonderful helper, but over time the cutting element wears out and there is a need to replace the ended fishing line. But not everyone knows how to refuel a fishing line in a trimmer. We suggest using step-by-step instructions with attached photos.

Instructions on how to wind fishing line onto a trim reel

1. 1. First you need to disassemble the trimmer head. Press the latch on the product body and turn the cover clockwise. We take out the bobbin.
2. Now we have to figure out how to wind the line onto the reel of the trimmer. We measure out about 6-7 m of fishing line and insert its end into the bobbin hole.
3. We wind the fishing line from two sides. The winding direction is always indicated on the bobbin in the form of an arrow.
4. We leave the ends of the cutting element 15 cm long free. Do not wind too much fishing line. Leave 6 mm between the outer edge of the bobbin and the fishing line.
5. We insert the remaining two ends of the fishing line into the opposite holes of the bobbin.
6. 
   We fix both ends in the grooves on the head housing.
7. We carefully install the spring back into the guide bobbins and into the head housing.
8. In order for the fishing line to be trimmed correctly, it is necessary that the bobbin goes back into the head housing (gently press it). If necessary, pull the free ends of the fishing line out. In turn, sharply pull the ends of the cutting element so that they come out of the grooves of the bobbin and freely pass through the holes on the head.
9. So, we figured out how to wind the line onto the reel of the trimmer. It remains only to combine all the grooves on the head housing and close the lid. Then we press the bobbin and begin to rotate it counterclockwise until it stops. While holding the bobbin, turn it slightly clockwise and release it. If there was a click sound, then it clicked into the head. If this does not happen, then you need to repeat the action again.
   
10. Pull the loose ends of the fishing line all the way.

Some tips

In this article, we figured out how to reel a fishing line on a trim reel. And if you did everything correctly, then when you press and hold the bobbin, it should stretch again. The fishing line for the trimmer is a very important element, without which the tool loses its functionality. In essence, this is the heart of the trimmer. Therefore, make the purchase in a specialized garden equipment store and approach the selection with special attention. When buying a new fishing line, be sure to compare it with a piece of the old used cutting element.