How to cover the roof with roofing material and do the job correctly and efficiently? This is the question asked by many ordinary people who decided themselves, without the help of professionals, to cover the roof of their house, shed or garage. Today they use not such material as in Soviet times, but a new one with stone chips, the laying of which consists of two layers: cushioning and reinforced with stone chips. The first is laid on a perfectly flat surface using mastic, a gas burner and an ice rink. It is necessary to carefully study the question of how to cover the roof with roofing material, and correctly prepare the foundation, since the quality and service life of the coating depend on this. It is better to do all the work in warm and dry time - in spring or summer.
Alignment
Before applying mastic to the surface, it must be carefully leveled, dried, rid of pits, bumps and completely cleaned of resin. Indeed, in the old days, the roof was covered with a thick layer of resin, on which roofing felt was glued. Over time, the resin began to crack and leak. Also, the cause of the leakage of the covered surface was the accumulation of condensate resin in the microcracks. It will also happen if material with stone chips is attached to the resin. Consider how to properly cover the roof with roofing material, so that leakage does not happen.
It is necessary to carefully remove the old coating, knock the resin down to the screed. If irregularities are found, it is advisable to level them with a new screed, heaped to the horizon by at least a centimeter or more, so that water can easily drain from the surface. This can be checked with a laser or water level. With the help of threads, lighthouses are placed, equal to which the cement screed is poured.
Styling process
The base must be dried, sweep resin, dust, dirt with a broom, and then apply the mastic with a roller or brush. Then wait until it sets, adhering to the time indicated on the package, which may vary due to temperature and humidity. After the mastic dries, the turn of the coating of roofing material begins. It needs two layers: a laying one, without pebbles, and a top one, with stone chips. There are also combined options, consisting of two layers at once.
How to cover the roof with roofing material?
You need to start coating from a lower point, so that the upper layers have the ability to overlap the lower ones. To make it more convenient to work, the sheets can be cut in advance with the necessary pieces. We apply the first sheet, heat the mastic with a gas burner along with the material to a certain temperature, which can be determined by the temperature tape. Then we apply the sheet to the mastic and roll it with a special roller. Uneven areas of the roof are trampled by experienced experts with their feet for better traction.
Laying in the rain
Many are interested in how to cover the roof with roofing material in rainy weather. There is only one answer - it is strictly forbidden to carry out such manipulations in the rain. It is better to wait for its termination, and dry the wet surface with a gas burner. But this is only in rare and hopeless situations.
Cost
It is also worth considering how much it costs to cover the roof with roofing material. On average, one roll of roofing material costs about 300 rubles. Depending on the area of the surface to be coated, it is necessary to calculate the required number of rolls, add nails or a stapler to this figure. Well, of course, you have to spend money on mastic. In comparison with other materials for roofing, roofing material is considered the cheapest and easiest to use material. This coating is practical and durable, requiring no additional maintenance.