Nowadays, building a house from aerated concrete is considered quite financially profitable, because this material belongs to the type of lightweight porous concrete. Such products are a great alternative to brick buildings. The construction is much faster, since the size of one block is much larger than a traditional brick. This material perfectly holds heat, but requires special protection during work and during operation of the building due to hygroscopicity. High-quality construction of a house from aerated concrete will completely depend on the correct construction technology.
It is possible to carry out work using these blocks by paying delivery to the site itself. However, in some situations, when a house is built from aerated concrete, the products are delivered on their own. Transportation should be in plastic packaging, which has a reliable seal to protect the units from moisture. During construction work, it is recommended to store the material under a canopy on a flat area. Also important is the fact that aerated concrete must be protected from mechanical stress that could adversely affect the quality of products.
Many people want to know how the phased construction of a house from aerated concrete is carried out, but it actually practically does not differ from the construction of buildings from other materials. First, an estimate is made for the construction of a new home. At this stage, certain measurements of the site are made to begin work. If a typical project is proposed, then the construction company takes on all the main concerns, building from the foundation to the roof. Otherwise, however, you will have to face certain problems at each stage.
First of all, it will be necessary to choose the
type of foundation that can withstand the load from the walls and roof so that the construction of a house from aerated concrete is not in jeopardy. Most often, a strip foundation is arranged, which is economically advantageous if the organization of a basement is provided. If necessary, the base can be made of the same aerated concrete. The use of blocks will significantly accelerate the work and will avoid additional insulation. Before masonry, the surface is carefully leveled using a
building level.As a rule, the construction of a house from aerated concrete is carried out using special glue with the processing of all the seams. It consists of a dry mixture, which is diluted with water to the desired density. A trowel applies glue, and alignment helps to make a spatula. Laying of each row is necessarily accompanied by a horizontal check, because any deviations can lead to negative consequences over time. Of course, the cost of the binder composition is slightly higher in comparison with cement mortar, however, due to the lower consumption of glue, considerable money can be saved.