In fact, gluing all types of wallpaper is identical, but it will not be correct to apply the old standards to new types of materials, for example, to vinyl wallpaper. This can lead to their damage, which is highly undesirable. So, if you are concerned about the question of how to glue vinyl wallpapers, then he will be considered later.
Before proceeding with this operation, it is necessary to make sure that the wallpaper is received for the desired article, as well as that the rolls have a single batch number. It is worth sticking two or three strips, and then carefully check them for defects. In case of marriage, contact the supplier immediately, and work should be stopped.
If we consider the question of how to glue vinyl wallpapers, then it should be said that at the first stage you need to do the preparation of the walls. They should be made smooth, even, clean and dry, you should get rid of flaking paint, signs of mold, grease, as well as old glue.
If the walls have just been plastered , then it is important to let them dry, and then apply a primer. An important condition is the priming of all the walls before gluing. Aqueous emulsion paint is completely unsuitable as a primer.
Vinyl wallpapers: how to glue
Now you should prepare the strip. This is done this way: it is necessary to cut off two canvases that are equal to the height of the ceiling in the room, while it is necessary to take into account the fit of the pattern and allowances of 5-10 centimeters for each of the strips. The strip should be cut off from the roll only after fitting the pattern on the sheet to a complete match. Each cut strip should be marked with a pencil in order, so that then there is no confusion.
And now we come close to the question of how to glue vinyl wallpapers. The strips must be glued strictly in the order in which they were cut from the roll. The first need to stick on a plumb line. Trimming wallpaper on the floor and ceiling should be done with a spatula using a fairly sharp knife. Glue should not get on the joints of wallpaper. If it gets on the surface of the sheets, it must be removed immediately with clean water and a sponge. Wallpaper at the edges should not be rubbed, since dried glue can damage their surface. It should immediately get rid of him if he got on the platbands and baseboards. Glue should be applied to the cut sheets. This concerns the question "how to glue
vinyl wallpapers on a paper basis." However, there is another type of base - non-woven. In this case, the glue should be evenly applied to the surface of the wall, after which gluing can be carried out.
When the process is completed, you need to make sure that the wallpaper is held firmly to the surface. It is worth saying that the described rules can only be called advisory, since they do not take into account all the nuances and features of the work. If you trust the experts in the question "how to glue vinyl wallpapers", then they will take full responsibility. If you started the work on your own, then you should do everything very carefully so as to prevent negative consequences.