Owners of private houses that do not have a centralized water supply system need to independently solve the problems associated with water supply. If a plot or garden can be completely watered with water from a natural reservoir or well, using a conventional pump for this, then such a system is completely inappropriate for housing. Only connecting the pumping station to the well will help to cope with this task. It is so powerful that the resource is enough to water the garden, trees, fill the tank with water, as well as the uninterrupted supply of water to the home.
Choose
To determine which pumping stations for wells are right for you, you need to deal with their main parts, that is, find out their composition, as well as points that are important to consider with special attention. First of all, the presence of a check valve is determined. With the help of it, it is possible to significantly extend the life of the station, to increase the safety of the service, since it provides protection against idling, when the water supply is interrupted for some reason. Another important point is the presence of an inlet filter that protects the pumping station itself, as well as a check valve from all kinds of contaminants. If necessary, the filter can be easily removed to clean.
Equipment
Well pumping stations should be equipped with tanks, in one part of which there is liquid, and in the second, air under pressure. This allows the appliance to work for a certain amount of time after the power is cut off. The tank in this case acts as a battery. Water is supplied due to the pressure of the air inside it, the check valve does not allow water to move back, so it only needs to move into the water pipe.
Thanks to the tank,
pumping stations for wells receive a number of advantages. Depending on the size, it always has 25-50 liters of water, which can be used for household needs, if the electricity is turned off. There is no need to install a storage tank in the attic.
The water supply system receives the required pressure to supply water to the bathroom, kitchen or bathroom. Well pumping stations last much longer by reducing the number of on / off switches.
Using
The principle of operation of this type of equipment is very simple and boils down to the following. At the initial stage, water is pumped into the tank. When it is completely full, the unit goes into standby mode, and this lasts until a certain pressure level is reached in the second part of the tank. Now in the house you can open taps to use water. The pump station switches on automatically as soon as the pressure inside the tank drops. And this will happen as many times as required. Automation clearly monitors the pressure level. If the unit overheats, it turns off, and after normalizing its condition, it is again turned on. In this case, the cooler is water that is pumped. Installing a pumping station in a well allows you to solve a number of problems in providing a home with water.