Curved walls with waves from warped material from time to time can only inspire experienced sailors and lovers of antiquity, but they are definitely not suitable for a modern room. If you decide once and for all to end all this disgrace, then you should read our article! So how to level the walls with drywall? First you need to find out that in this case two standard methods are used: with and without a framework.
As you might guess, in the first case, sheets of material are attached to a base specially created for such a case. It’s easier and faster to stick them directly to the wall (frameless method), but in this case it should at least slightly differ from the surface of the old tankodrome. So they often prefer to
align the walls with their own hands with drywall, having built a frame. As a rule, it is made of wood, but this material has a number of annoying technical flaws:
- No matter how strange it may seem, but such a design is much more difficult to install.
- Unfortunately, they often forget about thoroughly drying the material, as a result of which the wall can go exactly the same waves as it was on before the repair. And the crumbled pieces of gypsum will make the question of how to align the walls with drywall simply irrelevant.
Thus, when repairing, we strongly advise you not to save on suppliers of consumables. Much more reliable and easier to assemble is a metal profile, which also has better reliability and durability.
In addition, with the help of metal, repairs can be carried out in the premises of any purpose and operating mode. This material is not afraid of moisture, so even with differences in daily temperatures in the room and the formation of condensation, you can not worry about the condition of your walls. Are you still wondering how to level the walls with drywall? First of all, you need to buy guides and rack elements. Do not forget about the quality construction level, square, tape measure and self-tapping screws.
First, you need to fasten the guide profiles to the floor and ceiling , aligning them and fixing them properly, then you can proceed to fasten the racks. Be sure to remember that their step must be equal to the width of the sheet of material. Since it is possible to properly level the walls with drywall only with careful adherence to technology, forget about the haste. The proverb about seven dimensions in this case becomes extremely relevant.
After assembling the frame itself, it is necessary to proceed to fixing the sheets of drywall. It is best to use standard black self-tapping screws for this, which are made of oxidized metal. As a rule, a length of 25-32 mm is quite enough. For every 30-40 cm of area, one screw is taken.
So that the joints between the sheets do not resemble meteorite craters, they must be putty. First of all, you need to process those places where you screwed the screws. Repeatedly carry out the procedure using a special mesh that will prevent the putty from falling off. Your wall is ready! So you found out how to level the walls with drywall! There is nothing complicated in this, and therefore even a beginner can easily cope with it.