The huge selection that the construction market now represents is thought-provoking. Such a variety of technologies and materials that it is sometimes difficult to dwell on something. This is very well seen on the example of the assortment of roofing. You can choose rolled material, stop on the fold roof, use metal or bituminous tiles. So there is where your fantasy can take off. For each type of roofing material has its own requirements, which is desirable
to observe. The Monterrey metal tile will look good on a
gable roof. For flat roofs, roofing material can be used, and slate is better to lay on a slope with a slight slope.
The basis of any metal tile is metal. Usually this is cold rolled steel. The thickness of the sheet can be different, for roofs most often use 0.5mm. In some cases, you can take 0.4mm steel. From above and below, the metal protects a thin layer of zinc or its analogue, aluzinc. Then comes the corrosion protection. A polymer layer is applied to the front side. It can be polyester or plastisol. On the inside, the Monterrey metal tile is protected by a layer of varnish. The result is an inexpensive roofing material with good performance.
Having appeared for the first time in Finland, it has become popular in many countries.
The Monterrey metal tile, manufactured in Russia, is practically not inferior in quality to its Western counterparts. A huge plus is the ability to order sheets with certain sizes, which can correspond to the length of the slope of your roof. This will reduce the number of joints, and therefore save money. In some cases, the sheet length can reach up to 7m.
Installation of Monterrey metal tiles is not very complicated and differs little from laying other types. It is made in the form of natural tiles with a specific wavelength, which is 350 mm. The working size of the sheet in width is 1100 mm. Its height depends on the size of the wave and the grooves on the profile sheet. It ranges from 25 to 46 mm.
Start laying sheets from the lower right edge. It is best to invite specialists for this purpose. But you can do all the work yourself, observing the installation sequence. This applies not only to the laying of sheets, but also to the general preparation of the roof. A well-made crate, properly installed vapor barrier, as well as a preliminary calculation and purchase of the required amount of material will save any further problems.
That the roof from a metal tile "Monterrey" added brightness to your house, it is necessary to choose color of the top covering. The palette of colors and shades is selected individually for each particular case. To facilitate the installation of the roof, it is necessary to purchase additional elements. These are various levels which are fixed on eaves, protect the fad and valley.
The sequence with which the Monterrey metal tile is laid directly depends on the complexity of the design of the roof itself. Each sheet is best fixed with self-tapping screws. The crate pitch is calculated from the wavelength. In addition to vapor barrier film, you can use waterproofing. In order for the roof to be well ventilated, there must be an air gap. If you take into account and properly lay all the elements of this puff cake called "roof", then the noise of the rain will not interfere with your sleep.