Sometimes users who have a couple of computers at home or a computer and a laptop want to establish a network between them in order to transfer files from one device to another without the help of storage media. And here the question arises: "How to connect two computers to the local network?" This can be done through a direct connection.
It is worth noting that if you do everything yourself, it will be quite difficult. You can make the cable connecting the computers yourself, or you can purchase it in the store already ready. Suppose you bought a cable, that is, you do not need to bother with it. Understanding how to connect two computers to a local network, it is worth noting that the cable should be connected immediately to both devices. If there is a special indicator on the
Ethernet controller , it should glow green, and sometimes blink. In the case when the indicators do not light or glow only at one end, check the quality of the cable crimping and the absence of mechanical damage along it. It is also necessary to check the availability of special drivers for the controllers on the computer, and also to make sure that the hardware is installed correctly.
Settings
We continue to understand the question "how to connect two computers to the local network." Now we need to go to the process of setting parameters in the operating system itself. To do this, you need to open the control panel and find the option of network connections. Among the connections already present, find “Local Area Connection”. You must open the properties of this item by clicking on the right button of the manipulator. In the window that appears, you need to find the "Internet Protocol", and then call the properties again.
To get a local network of two computers, you need to assign each of them a specific network address that will allow you to identify it. Typically, the IP address is written in the standard format: EFGH, where the letters correspond to numbers in the range 0-255 for each. You have the opportunity to choose absolutely any numbers, but it is recommended to set the addresses within 192.168.0.1-192.168.0.254. It is important to remember that the last number must not match on the computers being connected, otherwise an identification error will occur. It will be most correct to choose addresses sequentially, so it will be easier to navigate. In all three windows, click OK. On the second computer, you must perform similar manipulations, remembering what its network address should be.
If we talk about how to properly connect the local network, then after all operations, double-click on the “Local Area Connection” shortcut, after which a status window will pop up in front of you. If configured correctly, you will see a message about the presence of a connection. If an error was made during the setup process, the connection will be limited.
Now you know how to connect two computers to the local network, so let's move on. The next step is to enable folder sharing. This is done so that you can move files between computers. To do this, you need to right-click on the manipulator on any folder or disk, and select "Sharing and Security" in the menu that appears. In order to make the folder available to the second computer, you need to check the box next to the appropriate item. Everything, the folder is available to work from another computer.