Bream fishing is one of the most fascinating types of fishing. After all, if a large individual pecks, then you can get a tremendous adrenaline rush! Bream - a fish is very finicky, adheres to almost one life, a favorite location containing food. In case of lack of food, the bream leaves the parking lot far and for a long time.
If the fisherman manages to choose the right bait, then it will be possible not only to keep the flock of bream in the right place, but also to lure it closer to the shore.
Optimal time and place of fishing
It has long been established by fishermen that the bream has 3 most active periods of zhor. The first is from mid-April to the spawning phase, the second is observed after spawning (from mid-May to mid-July), and the third is from August to September. Referring to this, we can say that for about 2 months the bream is not caught at all, but is it really so? As they say, there are a couple of exceptions to each rule. In our case, we will make a small adjustment: the fact is that by the middle of summer the reservoirs begin to overgrow tightly, which becomes a kind of "pasture" for predatory and white fish. Do not think that the bream at this time does not bite at all: it is just that the saturation effect occurs faster due to the abundance of food. You can go fishing at dawn for a couple of hours, and to continue is simply useless.
There are a myriad of factors affecting the biting of fish, not just bream. It is important to maintain silence, constantly feed and have patience - all this requires fishing. We catch the bream as carefully as possible, because just one wrong move can frighten the flock of cautious breams forever. Fishing on the bream is interesting because it keeps the fisherman in constant tension, and the anticipation of catching a large individual causes crazy excitement.
Bite. Proper sweeping and fighting
The choice of the moment of cutting deserves discussion, because how many lovers of bream fishing exist, there are so many opinions about this. It’s simply impossible to tell you the most effective cut. Fishermen have found that bream always pecks in different ways. Select the standard does not work. It all depends on the activity of the fish at the moment and on the bait used. It happens that when catching a baler, the antenna of the float rises slightly, then smoothly goes to the side, then it is necessary to cut it immediately. Be always on the alert, then you are guaranteed the most successful fishing! Fishing for bream is completely different from catching any small fish: you have to wait a very, very long time to bite. So you need to hook up immediately, otherwise you will have to bite your elbows and wait for the next about an hour. If fishing on the bream takes place in a very deep pond, then such a bite will often be noted: the antenna of the float after weak jerking will begin to sink to the bottom.
After a successful cut, it is recommended to slightly let the fishing line down while holding its stretch. The bream does not make sharp jerks to the bottom, but it is best to play it safe a bit. You need to try to fish out far away from the attached place, otherwise your fishing for bream can end - a flock of bream will simply scatter in all directions. Good luck!