Burbot is the only known representative of a huge family of cod, which lives exclusively in the fresh waters of rivers and large lakes. This view is more than others shrouded in tales and errors. Perhaps this is due to the fact that burbot leads a hidden lifestyle. The most active nibble in this fish is observed not in spring or summer, as in other species of river fish, but in late autumn. In the summer, she is passive and gets caught most often in inclement windy weather. Therefore, all anglers prepare their gear for burbot fishing in the fall. This predator can be caught on a spinning rod and on a donka. But when fishing from the shore, bottom tackle still brings the best results .
Snap Donkeys
The main criterion that is presented to the donka is its power. It does not require any expensive equipment. On the contrary, it is simple and unpretentious. Previously, burbot fishing tackle in the fall was a simple “bait” that did not include a fishing rod. It was a thick fishing line wound on an inertial reel. One end of it was firmly attached to a stick, which was deeply immersed in the ground. A sinker and 3-5 long leashes with large hooks were attached to the other end of the fishing line. Although such a tackle for burbot, although simple, it still has its own subtleties. So, the weight of the sinker is selected based on the severity of the current in the pond: the stronger it is, the greater the load. As for the leashes, they should be metal. The fact that there was a bite was notified by the bell, which served as a signaling device. Such simple tackle is now used for fishing burbot, especially among residents of villages and villages.
Modern bottom fishing equipment for burbot fishing in the fall
Bottom fishing tackle for burbot fishing can be done independently at home. Unlike a slightly archaic cast, the modern donkey version still takes into account the presence of a fishing rod. It should be short, and most importantly, powerful. It’s better to take the inertial coil. But it should be with a capacious drum. When collecting bottom gear, monolesque is preferred. Its diameter is from 0.4 to 0.6 mm. Of course, the thicker it is, the more reliable, but it is better not to overdo it. The reel must have at least 100 meters of fishing line. It is also important to choose the right leash. Tackles for fishing burbot in the fall must be with metal leashes. This predator has small and very sharp teeth, with which he, without putting much effort, gnaws any ordinary fishing line.
A lead “spoon” is used as a sinker. Its weight varies depending on the course. In low-flow reservoirs, 40 grams of weight is enough. But on large rivers with a strong current, a heavy weight is used - 100 grams or more. Tackles on burbot in the fall should be with large hooks. Expect that the bait will be either bait fish or a weighty bunch of worms. It is acceptable to install double hooks. As a
bite signaling device, ordinary bells or bells are taken. This is not at all fundamental. They can be installed both on the fishing line itself and on the top of the rod.