The store presents various speakers, which vary greatly in parameters. There are models with and without bass reflex. It should also be noted that devices will report on the number of channels. According to the installation method there are desktop, floor and wall modifications.
The power of the speaker starts at 5 watts. For models for personal computers put forward special requirements. Home cinema devices are also manufactured. Some buyers are looking for car speakers. In order not to make a mistake in choosing a quality model, you should consider the main types of speakers.
Single Band Devices
Single-lane modifications are made in the open and closed case. If you believe the experts, then the choice of acoustics should begin with a diffuser. These elements are most often installed dome type. Their conductivity should not exceed 8 microns. The crossover frequency limit depends on the bass reflex.
If you select a powerful model, then the speakers for acoustics must be lined. Special attention deserves the quality of the finish. Many models are made with Kevlar. Modifications with two amplifiers are rare. On average, the horizontal dispersion parameter for them is 15 degrees. The sensitivity of the system fluctuates around 80 dB. Emitters in devices of this type use the midrange series. There is a high-quality acoustics for the home in our time, about 50 thousand rubles.
Passive two-way speakers
Two-way passive acoustics is very popular. Amplifiers in models are often used with adapters. Devices are connected via the 3.5 mm RA connector. The choice of acoustics should be determined from the inspection parameters. Rated power must be in the region of 30 watts. For a home theater, this is enough. Also, experts advise paying attention to the diffuser. The ultimate conductivity parameter is on average 6 microns.
The horizontal dispersion depends on the phase inverter. It is mainly used in frontal type. The subwoofers of the model are used with various parameters. On average, the sensitivity should not exceed 80 dB. Microchips for speakers are used with regulators. Resistors for devices are selected on two terminals. To enhance the sound, capacitors are used.
Emitters are often installed midrange series. The vertical dispersion parameter, as a rule, is in the region of 50 degrees. The energy consumption indicator depends on the power of the bass reflex. A two-channel horn is rarely installed. For the receiver, these speakers are not the best way. The maximum crossover frequency is on average 130 Hz. Various filters are used to combat harmonic vibrations. In the store, high-quality two-way passive speakers are sold at a price of 63 thousand rubles.
Multiband Models
Multiband devices are used for home theaters. They are also great for mixers. Acoustic selection should begin with the performance of the device. The power parameter is on average 150 watts. Harmonic distortion protection is not installed on all devices. Special attention should be paid to the sensitivity of the bass reflex. As a rule, this parameter is within 70 dB.
To connect the system, the RA and PC connectors are used. Good bass is primarily provided by the subwoofer. An amplifier for it is more expedient to select it immediately with a filter. Phase inverters on the model are installed different. To improve the sound quality, some manufacturers use a vibration isolation layer. The horizontal dispersion index is on average 30 degrees. Electricity consumption largely depends on the power of the speaker system.
Emitters for devices are selected series midrange. 12 cm speakers for a home cinema will work great. Chips are used with a thyristor unit. For receivers, multi-band modifications are rarely used. A removable grill on models is welcome. The case is better to choose with a Kevlar coating. You can buy a quality model on the market at a price of 75 thousand rubles.
Floor models
Floor standing devices are suitable for home theaters as well as personal computers. The choice of acoustics is better to start with an examination of the parameters. However, the appearance of the device also plays an important role. If you look at a simple model, then the power must be in the region of 40 watts. The horizontal dispersion of a good system is 20 degrees. The average electricity consumption is 300 V.
To combat harmonic distortion, directional filters are used. The PAC system is not used on all models. Due to it, the quality of bass is significantly improved. Subwoofers on devices are installed with sensitivity from 50 dB. Coating is most often used lacquer type. Labyrinth systems are not common. The adapter for the model must be with a speaker. To connect the device, connectors of various diameters are used. The most common is a linear output of 3.5 mm. Devices with emitters of the midrange series are in great demand. The sound quality is quite high. However, it is important to consider the high cost of goods. Models with CH emitters are produced without phase inverters.
The threshold conductivity parameter for them is not more than 4 microns. Amplifier matching usually takes a lot of time. Also, models often have problems with harmonic distortion. The horizontal dispersion in the devices is about 40 degrees. Cases are made of plywood and fiberboard. The maximum crossover frequency, as a rule, does not exceed 120 Hz. The user is able to buy a high-quality floor model of low power at a price of 35 thousand rubles.
Devices for personal computers
Computer acoustics are most often produced without amplifiers. In this case, diffusers are used with one adapter. The average power of the model is 25 watts. The design of the system is quite different. How to choose high-quality acoustics? The emitters in the devices must be of the midrange series. Horn is not used in all versions. Horizontal dispersion, as a rule, does not exceed 10 degrees.
The maximum crossover frequency is at 200 Hz. If you select a universal model, the subwoofer (acoustics) must be designed for 20 dB. Speakers are recommended to be selected with a diameter of not more than 6 cm. To improve the sound quality, manufacturers use filters. Computer acoustics with wired counterparts are now in great demand. The RAS system in models is rare. The case is most often made of a closed type.
If we consider inexpensive modifications, then they use diode-type microcircuits. The conductivity index for such systems is on average 2.2 microns. The maximum sensitivity of the speakers does not exceed 30 dB. For receivers, devices do not fit well. Models are connected via 3.5 mm line connectors. Nowadays you can buy a good system for a computer at a price of 36 thousand rubles.
Models for cars
Car speakers are manufactured with a power of 30 watts or more. Filters are used wired type. How to choose good quality acoustics? The frequency parameter should not be lower than 120 Hz. Protection systems are used in various series. To improve the sound quality, vibration isolation material is used. Microcircuits are installed both with regulators and without it. There is no PAC system in devices. The threshold impedance in systems is negligible. High-quality car speakers worth about 44 thousand rubles.
Open drawer speakers
Modifications with open drawers are rare in stores. Diffusers are suitable for them dome type. Amplifiers are usually installed with a bass reflex. The sensitivity parameter of the speakers is at the level of 50 dB. If we consider models of low power, then they use a contact filter. To combat harmonic vibrations, it fits great. The threshold impedance index for speakers is on average 10 ohms. It is also important to note that devices with wave tubes are on the market. There is good acoustics for a home of about 64 thousand rubles.
Box models
Devices with closed drawers are very popular. They are usually produced in high power. For the receiver or mixers, the devices are great. It is also important to note that they are easy to use. The emitters in the devices are installed in the midrange and midrange series. The maximum crossover frequency is on average 140 Hz. Choosing a good model is pretty simple.
The column power should be about 50 watts. For a home theater, this is enough. Also, experts recommend that you familiarize yourself with the performance of the subwoofer. The sensitivity parameter does not exceed 80 dB. The horizontal dispersion of good systems is 15 degrees. Electricity consumption is highly dependent on the bass reflex. The price of the device starts from 30 thousand rubles.
Choosing a hi-fi model with a speaker
Hi-Fi speakers with a horn are typically used for multi-channel receivers. The sound quality is pretty high. The speakers are closed. To choose a good device, you should first evaluate the parameters of the model. Indicator speaker power starts at 20 watts. Moreover, the horizontal dispersion on average does not exceed 30 degrees. The crossover frequency is largely dependent on the bass reflex.
It is also important to consider the design features of the models. Systems are bad for a mixer. Filters in devices are rarely set. Coating is most often used lacquer type. Some models use a core. It is mounted on a diffuser. The threshold conductivity parameter of the element is about 4 microns. There is a high-quality Hi-Fi acoustics with a mouthpiece of about 75 thousand rubles.
Labyrinth speakers
Devices with a labyrinth system are made most often for personal computers and mixers. The sound quality is excellent. However, it is important to note that the model should be selected with a midrange emitter. The horizontal dispersion of the models is on average 30 degrees. Power starts at 12 V. Some speakers use a wave tube.
The diffuser under it is selected dome type. The maximum crossover frequency in systems of this type is at least 90 Hz. The vertical dispersion is about 40 degrees. Modifications with gaskets are very rare. Devices are most often connected via terminals. However, there are models with standard line outputs. A user can buy a good device on the market at a price of 40 thousand rubles.
Tests of the speaker system Yamaha SET NS-7390
SET NS-7390 is Yamaha's best home acoustics. The specified model was primarily tested with a single-channel receiver. In this case, the rated power is at 30 watts. The maximum frequency of the device is 130 Hz. The vibration isolation layer of the model is used in high quality. No harmonic oscillations occurred during testing.
It should be noted separately that the system uses reliable protection. Filters in this case are installed pass-through type. The crossover of the model is provided with a bass reflex. Failures in it are extremely rare. You can buy a device on the market at a price of 55 thousand rubles.
Yamaha SET NS-7360 Review
The specified model reviews, as a rule, get good. An overview of acoustics is better to start with a listing of the benefits. These include a quality wired bass reflex and dome type diffuser. The specified device was tested on a two-channel receiver. Harmonic distortion in this case is negligible. If you believe the reviews of experts, the emitter has a high conductivity.
The maximum crossover frequency is at 400 Hz. The sensitivity of the speaker is a maximum of 30 dB. However, for a three-channel type receiver, the model is not suitable. First of all, the sound quality significantly spoils impulse noise. In this case, the filter copes with them poorly. The sealant in the model is used of small thickness. The head of the speaker system is used dynamic type. There is no wave tube in the device. This speaker system is sold at a price of 88 thousand rubles.
Tests of the Butts speaker system
Acoustics "Butts" was tested on various receivers. As a result, we can say that the model proved to be excellent. The maximum power parameter is 30 watts. Problems with bass in the device are rare. At maximum load, wheezing sometimes appears. However, experts claim that the filter has a high sensitivity.
Harmonic jumps to this speaker system are not scary. Of particular note is the quality of the diffuser. The parameter of ultimate conductivity is 2 microns. The amplifier for the device is selected with an adapter. The model is connected to the network through a line output. The PAC system by the specified device is not supported.
If you believe the reviews, speakers for acoustics are used in high quality. Their diagonal is 13 cm. The wave treba is installed with a regulator. The core is applied resistor type. Also noteworthy is the high-quality enclosed enclosure. There are terminal blocks on the back of the device. Acoustics "Butts" is about 60 thousand rubles.
JBL Northridge E80 review
Northridge E80 is the best acoustics for the computer of the JBL trademark. The specified system of reviews from customers receives mostly good. For multi-channel receivers, the device is great. The subwoofer (acoustics) is designed for 20 dB. The output power of the model is 30 watts. A harmonic protection system is provided.
For mixers, the model works well. The phase inverter is used rear type. Vibration insulation material is located only on the rear wall of the housing. The microcircuit for the speaker system is used with an adapter and a regulator. PAC technology is supported by this model. Thus, bass problems are rare. Speakers are used at 13 cm. The maximum crossover frequency is at around 200 Hz.
The horizontal dispersion is 20 degrees. The finish of the model is just wonderful, and the design was appreciated by many buyers on the positive side. The emitter in this case is used series CH. The head is applied dynamic type. There is no seal for the speaker system. However, the sound quality is not much displayed. The indicated audio-acoustics are worth about 57 thousand rubles.
JBL Northridge E95 device overview
This speaker system receives mostly positive feedback. Specialists and buyers praise her for the high clock speed of the crossover. The diffuser of the model is of a transitional type. A device with a single-channel receiver was tested. As a result, we can say that the model has good conductivity. The bass quality in the device is excellent. The threshold impedance is at least 8 ohms. The maximum crossover frequency is 240 Hz. Horizontal dispersion maximum is 30 degrees. The price of this speaker system is around 48 thousand rubles.